NorCal Craigslist finds

Haha, dick!

 

WHAT all you guys are selling your tepui's.
I would of never predicted this shit. I vouch for yours being the best sell as there has been some hot ass in yours.
Those stains are worth money.lol

 

Well there goes your profit margin @tacomgee

 

No way , extra for hot girl wet spots.

 

Lol that’s what he told you they were?

 

Reposting. OBO

 

SF Bay Area Sale only - For sale is a custom bed rack for a 2005-2015 Toyota Tacoma. It is designed to carry a Rooftop Tent and other gear above the bed of a Tacoma.

What's special about it is the height is perfect so it does not obstruct rear window vision. It is right on the window line so it's not too high either. And even better, the height is designed so the tailgate can carry up to 6 bikes of any wheelsize and still clear the rack when used with a 6-foot bed truck



The rack is also modular so the two crossbars can be removed independently. This can be very handy hauling huge items without having to remove the whole rack. The rack can be disassembled into four pieces and lay completely flat so it can be stored neatly without requiring much space.

The rack is compatible with 2005-2015 Tacomas only as it fastens to the factory rails and can be slid back and forth for positioning. The rack is supported by the bed sides completely so no load is put on the rails. There is no space taken on the pickup bed as well. No holes have to be drilled to install.

All the hardware is included and only takes a few minutes to install. The rack is powdercoated textured black so it is fully protected from the elements.

The rack was hand-built by Randybuilt Industries and the pipes were perfectly bent to have the correct bends and angles to complement the truck. Welds are very good indeed and we'll include photos before the rack was powdercoated. The rack cost $1000 to build in labor and materials. Powdercoating cost $200 for a total of $1200.

We previously had the Thule rack system on the truck for $900 but it was just too high and ugly. It was wobbly too. The AllPro modular system is $900 before powdercoating but it just huge and too long that it takes up the tailgate usability with bikes.


fcebedo@yahoo.com

 

NM could be a nice 4wd project

https://modesto.craigslist.org/cto/d/1996-toyota-4runner-manual/6517369176.html

 

NM: nice looking ARB bumper, and possible winch

https://sfbay.craigslist.org/nby/pts/d/tacoma-front-bumper-arb/6517167372.html

 

That custom rear bumper is terrible hahah

 

Werent you looking for a rear bumper?

 

That's the preferred one for later 2nd gens, the 12+ sticks out an extra few inches and has higher kinda goofy looking bars. Tempting. Some mods required to make it fit on a 15, nothing major. If I wasn't moving would probably jump on this. They are 1060$ delivered brand new from bumpersuperstore.com so the price with lights is good.

 

https://sfbay.craigslist.org/nby/ctd/d/2011-toyota-tacoma-prerunner/6513784812.html

 

Short bed?

 

I was eyeballing a DCSB TRD OR 4x4 in the bay area that the dealer had listed as a Prerunner for a low price, but when I asked for the Carfax something was off about it.

 

Can confirm.

 

Cup holders-2

 

Any reason it wouldn’t be good for an ‘09?

 

Lol hard pass