Lift problem from a shop

Just recently did bilstien 5100’s and old man emu’s up front. I had it installed at a shop. When I picked it up they put the old man emu coils on the top notch (5th i believe). To my knowledge ome coils where supposed to be installed at the lowest setting on the bilstiens. Will this hurt anything? Shop isnt opened for another 2 days. Would appreciate some advice thanks. Told them it was 2 inches up front and i had the ring at the lowest setting when i gave it to him...

 

what ome coils did you go with?

 

Ome 887. For the most part the ride actually feels great. Im just asking if something may happen running it the way i have it

 

there is chart for that particular spring at specific settings, I think headstrong offroad will have that link. Could result in topping out excessively. I know with 2888's the recommended is bottom notch, some however are running 0.85, but I suspect that is with a plate bumper/winch.

 

• OME 887: 400mm in height 590 pound spring rate
• OME 888: 405 mm in height 590 pound spring rate

so I'm thinking 0.85(second notch), maybe 3rd, but definitely not the 5th.

heres a good reference link
https://www.headstrongoffroad.com/uploads/1/1/8/4/11846658/lift_guide.pdf

 

5th notch you could suffer bottoming the shock out. The shocks do most of the lifting so you should drop it to the 2nd(.85) notch at your first opportunity.

 

Do you think it would be fine to drive it around until the shop opens tuesday?

 

Yea just don’t go off-roading like your avatar pic and you will be fine. Avoid major potholes too

 

Thanks