PrInSu Design Studio Roof Racks BS Thread

I also just ordered a 6’ Toprac. Shipping date is showing 4/6

 

Give us a call in the morning... we have some special mounts for RTT's that will work great for your Prinsu rack. It is a new and upcoming Prinsu product! Toll Free: 866-522-0697

 

I think you guys will find you will receive your racks in 2 weeks or less. Many racks are shipping right out within a day or two! Depending on where they are shipping to maybe even a week!

 

Took the cab rack off my old Hilux and put it on my Tacoma. Gave me a reason to install some limb savers on it.

 

Is that solar up on the rack?

 

It is. A 100 watt renogy panel.

 

Absolutely!!! I try and drown it out with music or just open up my back window which really helps...

 

Would you be able to mount on the side?

 

This is probably a dumb question but I've looked back at least 30 pages and haven't seen what I'm looking for.

I just got two rotopax with the standard mounts. How is everyone mounting their rotopax to the rack?

 

1/4" carriage bolts

 

How tho

 

You could use one of the load panels
http://www.prinsudesignstudio.com/product-page/load-panel-single

 

That’s a sweet idea, but crazy expensive for a small sheet of steel that was cmc’d..

Didn’t realize they go all the way across, but still

 

Received my shipping bill today. Says the 24th!

 

I'm still loving my Cabrac, but I have a question about its drainage or lack thereof. After I wash it and it sits overnight or with a heavy rain, lots of water drains out when I start driving, even after sitting for upwards of 12 hours. Any solutions? Thanks.

 

Sounds like water is sitting in the crossbars. If you really want to fix it you could drill through the middle all of them to create drain holes. One hole in the center of the bar should be enough

 

Thanks.

 

Either drill holes in the mount or offset it just a tad to line up in the slots

 

Finally got around to reinstalling my prinsu with washers on the mounting feet to account for the topper curvature. Well, it introduced another problem in that the topper shop installed the rails as far apart as possible when the feet were flat, so now the the feet missed the rails by about 1/2" when at their widest setting. Solutions: more washers!



These washers on the cross beams allowed me to widen the feet just enough for both the mount on the rails.





Finished!