5100s with OME 884 coils.

Hey guys,

I'm currently running 5100s at 1.75" of front lift on stock coils. I think the ride is a little rough. I would like to run OME 884's on the 5100's but keep the height no higher then 2.5". What setting should I put the 5100's at to achieve a better ride and get around 2 inches of lift? I'm guessing 884's with the 5100s set at .85? Thanks for any assistance folks.

- Richard

 

0... always 0 when using ome springs

 

Solus,

Thanks for the quick response. About how much lift would I get with the 884s on stock setting? good to see another local yota owner.

- Richard

 

you should see 2" or pretty close.

I have the 885 springs on mine and with out the spacer I between 2.25 and 2.5. I now have the spacer on it and I'm just over 3" at about 3.25ish

have you considered the 885 springs?

hey a bunch of us went to hollister a few weekends ago, we're gonna plan another trip when it get drier... you should keep your eye for the thread when I make it

 

I actually wanted 885's at first but did not have a aftermarket front bumper to compensate for the additional weight which equals out to be a stiffer ride with stock bumper. I would like to have a better ride and a little bit more lift without the harsher conditions. I'm assuming 884's set a zero on the 5100s is something I am looking for... I hope it's around 2 inches in the front, because that would be perfect to match the rear TSB 4 leaf pack and rear 5100s I've got Yeaaah I'm down for Hollister Hills any day!

- Richard lurking TW before bed

 

Always? Why?

 

Just had 5100s and 884s installed yesterday, set at zero, I have a deavers AAL in the rear.

And I just realized this thread is 7 years old.

 

Thread Revival again..

bgsmith, do you have the tsb springs as well in the rear?

 

I do, they sagged pretty bad compared to the old ones.

 

I gotcha. Are those 285s in the picture? I really like the stance of your truck.

 

265/75/16s

 

@bgsmith how is the ride compared to stock? I'm thinking of doing the same setup. Did you do UCA's?

 

I don't really remember what stock was like as I had 5100s with stock coils before this, but the current setup is better than it was, I did not do UCAs.

 

Hey man thread revival, I’ve already got bilstein 5100’s on all four corners and looking at getting OME 884’s/ 1/4 driver side spacer/ and the 1.5 to 2” deaver aal. Is this the exact same setup you have?

 

Yup

 

Awesome, thanks

 

Me too

 

me three.

 

You running 5100 with 884 coils ??2wd or 4x ? And what did you do to the rear ? Looks really good .

 

Thanks. Theyre 885 coils. 2wd got a 2.5in lift. Rear is a Deaver AAL.