What Have You Done To Your 2nd Gen Tacoma Today?

Yes sir. Also have a row to give light through the lower valance.

 

Very Nice!

I went a little overboard with mine.

 

Looks great! Illegal as hell! Don't run them on road!

 

My intent was to keep it subtle.

 

I run them on the freeway sometimes and occasionally in the rain. I know it isn't legal of course, I'm riding clean though. Wonder what the ticket would cost.

 

Probably pretty serious. Impersonating Law Enforcement would be the charge.

 

Whoa, I never thought about that. Glad you said that. I should think more (in certain cases anyways) thanks

 

A couple pics of the center console panel so far. It's made up of 3 layers of abs, 2 @ 1/4" and 1 @ 3/16" which is 11/16", the total thickness of the small push switches back to the lip on the snap. Here's the back, the recessed area to the left is where the two stacked pressure guages will go after some 1/8" abs is glued there. On the far end is where the pressure regulator will go.
And here's a pic of the front side, I still have to adjust the jig a bit more to get the switch clearance correct on the first switch hole before finishing the rest, when finished there's only ~1mm between the holes on the front. . The ends get cut back and the long edges cut/sanded to follow the template lines drawn on the blue tape. The switches are offset to the low side because from the drivers perspective only the lower 2" of the panel is visible so the switches are centered vertically in that space. Both the guages and the regulator will be simple cuts with a two different hole saws each on the drill press.

 

Red and Blue lights are definitely something you DO NOT want to run on the street for this very reason.

 

Yep I've been there. I didn't get a ticket.

 

1/2” top plate spacer on driver’s side front to fix “taco lean” installed this evening. Took about 90 minutes start to finish, mostly because I always invite Murphy along to help out....

 

That seems obvious but thanks. Got me thinking though just with blues alone, sometimes they try to stick it to you. I'm always very respectful with Leo's though, doesn't do any good to try and prove a point, plus I respect what they do.

 

Cattle dog? Co-pilot mods are awesome.

Should have kept reading. I have a shepherd/heeler mix and a full heeler. They are awesome dogs.

 

Did you have to get any special kind of mounts for the speakers to fit in the doors or were they plug n play?

 

Got mine the other day also . Making an appointment because they never fixed the old issue with the seatbelts for access cabs . Mine will not retract half the time !

 

Also removed the 4 sand tubes from the bed . It better not snow anymore ! Come on warm weather !

 

Now you did it! All hell's gonna break loose!

 

https://www.ebay.com/i/162764201038?chn=ps&dispItem=1 put some yellow overlays on my fogs, very easy to apply but im not happy with the fact that you have to trim the edges with a razor which ended up jaggedy , the kit is great they give you 3 overlays if you screw up, my advice is to pre cut the overlay at 3 inch diameter( I used a 3 inch coffee mug as a template) than apply the overlays come in at 31/2 inch leaving material to cut off with a razor.

 

Awesome, I just ordered the exact same setup for my 08

 

And so far he’s super smart! The only thing I have to pay super attention to is catching him right when he goes to chew a shoe and switch it with a chew toy.