Great White Taco build

Its paint not blood

 

Doubtful, there's some other brands with a 295/75R16, which is still .5-.75" short of the 285/75R17 but cooper doesn't have any tires in that size, they have the 295/70r17. 16" tires are going to be more and more difficult to come by because the market isn't as strong for them, many new vehicles can't even fit a 16 so manufacturers don't want to design sizes for them.

 

Yea mine does...I even have a paint burn mark now because of it. #3-5lyfe

 

How are you rubbing the frame? Your 3.5in further away from the frame

 

@HolyHandGrenade do i trim less in the rear?

 

Getting there...

 

I did the same front and rear.

Bastid...

 

Have any pics of your firewall?

 

Not with the final bashing done. I can snap one later.

 

Snap many and find out what those 3 bolts do I'm doing round 2 with the BFH in the morning and need some recon

 

37s are my next tire. the rear is easy enough and i think LT will make the front relatively painless. i already have a cab relocate sitting around too

 

38s are my next tire.

 

bet

 

https://youtu.be/TL7xrE9EYd4

 

42's buddy! That's what I'm talking about.

 

I think it hit when it was getting cycled. A lot of my stuff is marked up though in my wheel well by having dirties.

 

The top 2 bolts/scews come in behind the wire harness in kick panel that lower bolt is 4 inches below those and can't be seen from inside the cab. I think it's just extra parts

 

Oh sweet. So if I manage to fling water in there it’s getting on wires. I think I’ll get some sheet metal and weld over the hole I created.

 

You punched in the lowest bolt? I pulled the grommet next to that one today and wedged a light in front of it. I couldn't see light in the cab or in the pocket that holds the cab mount bolt. I pulled that lowest bolt today. It's a coarser thread and had corrosion on the threads. When I tightened it back it had little to grab onto and kept spinning. I think it's just threaded into plastic. Need to get a parts diagram and see what it really is. As far as I could tell that lowest bolt does not enter the main cab but I need to do more research.

 

I only saw 2 bolts when I was hammering stuff. It was the left hand bolt on the passenger side.

I’ll have to pull the interior panels and see. I could just fill it in with weld if it’s not important.