Northern Virginia Roll Call

Thanks mate!

 

@yellowdogpaddler I have given you a follow too!

 

It's not fogs. 4 cylinders aren't prewired. I don't know what it's for though.

 

Nice meeting you the other day!

I just spoke with Kim, the Chaos admin. She is welcome to assist in planning Toyota events at Chaos Off-Road Park as well as extending the invitation to participate at the regularly scheduled Chaos events this season. I'm guessing the admins/moderators for this Northern Virginia/Virginia sub-forum can assist in the planning details. Her contact info is as follows:

Park@chaosoffroad.com or 410-499-3475

There are always going to be A LOT of Jeeps at the Chaos events, but they are a great group of wheelers. I have an 04 Nissan Xterra and they have been very welcoming and dont care what you drive. If anyone has any questions, feel free to check out the Chaos Off-road Park facebook page (admins respond in a timely manner).

Thanks for inviting me into this group. I've only been able to find a handful of Toyota folks in the past to go off-road with and its always been a good time. Looking forward to seeing you guys out there this season.

 

Let's do it! Just googled and Chaos is pretty close.

 

I think it is bed power. Which is weird - I didn't think it would be pre-wired for anything. But it is definitely an OEM blank with wires attached!

 

I'd post it up in the 2nd Gen thread. I'll bet someone knows...

 

Daddy daycare closed early today.

 

I think I figured it out, at least that's what the owner's manual would have me believe. It shouldn't be an issue until I run out of blanks.

 

Part 1 done, front installed.
Tires tomorrow along with rear leafs.
Rolling SC style for the evening

 

Nice! What lift did you go with?

 

Very nice

 

5100s and 885s,
Deaver AAL for the back tomorrow

 

Solid, need to go test it out soon!

 

Big thank you to @PyritePirateBill
We had the front and rear done in just about an hour.
And alignment isn't too far off, drove home on the toll road and didnt wander or pull.

 

You're welcome bro! See ya again tomorrow

 

Yep. Right next to the southern tip of Sleepy Creek. I'm definitely down for going, even if it would be to just watch others wheeling... but you know that ain't happening!

 

I don't think it's for the bed power. I don't think that was even an option on the 4 cylinder. The plug will pull out of the blank, so you can just tape it up out of the way if you need the spot where it is. My best guess would be that it's for the Clutch Start Cancel.

 

Exact same setup I am interested in. Did you guys do the ECGS bushing while you were in there?

 

No not yet