Let’s see dem Silver Tacos!!!

Are these the OEM steps? Can I get a couple more pictures of them on your truck? This is the look I'm going for.

 

No sir, it’s actually the Canadian walking bridge in canadian, tx- it’s a pretty spot just on the outside of town and crosses over the Canadian river

 

It does look very familiar, I most likely stopped there for pics at some point. I used to hunt Texas Historical Commission markers, old rural county courthouses, etc. way before GPS was readily available.

 

I bet you did also.... lots of historical markers around these parts sooooo- yessir- If you are ever through again stop in and say hi- couple good coffee shops in town. Grace and peace my friend

 

With the 2nd Gen TRD Pro suspension installed. Thinking about removing the black derp from the wheels?

 

Got new shews for the taco last week.

 

Went camping for 4/06 day

 

Yes, these are 2nd gen boards.

$467 Pt212-35055 Running Board

Pt212-35055 I believe. I have them on my 2016. Fit nice and tight to the rockers, actually just touch the rubber plugs. I’ll take a few pics tomorrow

 

I picked up some (2nd gen running boards) just today.

 

Those actually look like the 3rd gen cast aluminum running boards, not the plastic cover on steel frame 2nd gen ones

 

Thanks. I do like those, but dang they're expensive. Not finding a deal on them anywhere.

 

I was looking for those too, but settled on 2nd gen ones coz saw them cheap. The cast aluminum ones pop up for $300-350 occasionally, but always in other parts of the country from me.

 

I ended up ordering the 2nd gen ones. I liked them on my 2nd gen, just wanted to try something different. But not at that price.

 

Same here, always in another state or way far away, I'll do either these or the 5" ovals but still never close.

 

Can I get a side shot? I've got those exact wheels going on in a little less than two weeks, so I'd love to see some more angles. I sold my black ones to go gunmetal.

 

I was really hesitant on these wheels when I first saw them but I think they look great after all. White out on the BFGs is just icing on the cake. I’ll PM you a couple more side shots tomorrow in better lighting.

 

This looks so perfect!

 

Yep, gunmetal is the way to go. Looking forward to the PM.

 

Was your installation straightforward? I can't get one bolt on the drivers front. Seems the bracket might be a little bent from the factory.. wondering if I'm just not smart enough to figure it out, lol.

 

I bought from a guy who works at firestone. He put it on lift and put them on. I didn’t see him run into any problems.