Stech Switch System

I ran it inside to an add a fuse on the interior fuse panel.

 

Thanks , Keep us posted cause i just pulled the trigger and just purchased this. Hope to get it tomorrow they said.

 

It’s not hard at all. Just need to make about a 3/4 inch slit in the grommet.

 

Thanks hope to get the kit tomorrow.

 

Did you cut it to the right or left of the harness? Or above the hood latch cable?

 

Thanks for the heads up on the discount code, ordered. Have a bunch of lights coming, this will make wiring a breeze.

 

To the left of the harness.

 

I got through. Can someone tell me what fuse they tapped into for the ACC wire? I gave my voltmeter to my dad and prob won’t get it back lol

 

Did you figure this out yet? I just tapped one of the fuses on the interior fuse panel. Some are constant hit and some are ignition dependent.

 

Yea. I tapped into the headlight switch fuse under the drivers side of dash. All fuses under the hood were hot all the time.

 

So did you install a ground bus bar or are you just grounding your lights somewhere else?

 

Just got mine in. Wow what did you all do with the long battery lead? I only need a couple feet on that one.

 

Haven't gotten any lights in yet to get to that. I have never done a bus bar.

 

I used my entire lead, but I mounted on the passenger side.

 

following....

 

I just bunched it up nice and neat. Zip tied and tucked away under the box.

 

Got mine all done internet is in and out so more to come later.

 

Here is my review and pictures of my install. I purchased the Stech switch system and shortly found out later there are a few others very similar at a lower price. This is just a basic relay fuse and switch system. No extras, made with 14 & 16 AWG wire on 40 amp relays with 30 and 20 amp fuses. I question this but will not be loading it to the max and will be using 15 amp fuses supplied with my lights. I also added a 80 amp resetting fuse on the positive line and a ground bus bar. The positive lead for the system is very long. I cut it down to a foot crimped a new lug on and attached it to the load side of the 80amp fuse. I mounted the switch plate in the over head sunglasses holder. I had to fab a small bracket to hold it in place. This was done with a couple small bolts and double sided tape to hold the switch to the bracket. I attached the red fuse tap to the ACC fuse inside. The switch is on when the truck is on and is pretty bright. Make sure your stickers are centered on the switches or it will effect the operation of the switch. Here

 

Couple more.

 

Where are you guys finding that push button switch panel on their site ? I’m only
finding the rocker switch panel set ups...post the SKU