What have you done to your Tacoma today? 1st Gen Edition

nice. Glad to hear.

 

Snorkel!!! Kidding, honestly though, i think my air filter plugs up faster now with it, which makes sense to me.

 

How beneficial is a snorkel compared to the stock intake?

I love my K&N but not a fan of how dirty the MAF gets. Always get a P0171 even few months. I know it sucks hot engine air but I like it for the looks and the noise. You’re only going 30 but it sounds like you’re doing 70.

 

I have a PDF for all the part numbers but I have yet to figure out how to share it, anytime I try it always says it's locked or some shit.

Front plates are lame and a waste of metal, you'd think California would be all about saving resources.

Illinois is.... well... special.

 

actually when was the last time you changed you air filter @Speedytech7

 

Pretty recently, it's very clean, maybe two months old but I don't drive the taco that often either.

 

Okay I may have gotten it to where I can share the PDF for the part numbers for the 95-00 Tacomas (most parts are the same for 01-04 I believe anyhow) https://files.acrobat.com/a/preview/8a2bf171-70a3-4437-b9ff-6020233045ab

 

Works for me!

 

Sweet! I can't remember where I found that but I use it all the time and figured some on here could use it as well.

 

I have a pdf version of the factory service manual, but the chapters aren’t labeled

 

That sounds like hell lol.

 

Well according to this the part I’ve been looking for doesn’t exist....

 

What part?

 

There’s a rod that goes between 5 and 6, inside of 4

 

Gotcha, yeah there are some small parts it doesn't have for whatever reason, its likely something Toyota doesn't sell is my guess.

 

No one sells it, or knows what it is.

I’m hoping I can get it out of the part @BartMaster1234 put in the mail.

If not I’ll just continue using a screw driver.

 

I sent you the entire ignition system so I’m sure it will be there. You should probably just swap your key cylinder out of your old one and just use the one I sent you

 

If I can get the key out of the new one....

 

I think it will be easier if you took your old key cylinder and the ignition I’m sending you to a locksmith and have them swap it. I have no idea how to remove that key cylinder without the original key.

Pick-n-Pull recycles the keys after the cars come into the yard, unfortunately.

 

It is.