What Have You Done To Your 2nd Gen Tacoma Today?

So I put in a new wheel bearing assembly this past weekend. Put about 100 miles on the truck since then. Now coming from that side anytime I'm under 10 mph there is a metal on metal squeak. I haven't had the time to look at it but I'm guessing its something to do with the rotor and brake pad. Does anyone have any suggestions?

 

Bent rotor shield?

 

Quite possibly, I had to use a lot of pb blast and it took some work to get the old assembly off. When I take my tire off to check the wheel spacer torque this evening I'll look at that. It seems like it would be the most logical.

 

Lift the tire up and spin by hand. You should beable to pin point it. The bent shield is common when doing that much work. Just needs to be slightly off to hit the wheel.

 

Will do. Thanks for your help!

 

OH MAN DECISIONS DECISIONS DECISIONS. Just started looking at lift kits. Way too many options like the adjustable but love Dakar springs.will be puting a good bumper in the front n back with full skids.but like my stock rims

 

Can't go wrong with king, fox or icon. And yes in that order.

 

I am leaning towards the icon fronts but ome rears. Do they mix well?

 

I've not run that setup but I'm sure others have. Not many choices for rear leaf springs.

I'm going to run fox up front, rear ome leafs and fox rear shocks.

 

routed all mine to the front

 

Installed my KC lights today

 

I haven't done anything, yet, but I can tell you what I'm doing...

 

Man, that's really sharp looking!

 

Id need a pic when you've time

 

Got my 255's mounted today

 

That's what it was. I was able to climb under it during my lunch, it was barely touching the rotor in two spots.

 

I can't count how many times I've had to do that. Lol

 

At least it's a fix that only takes a minute

 

How tight do you put in the new camry union

 

Where'd you order the vinyl?