What Have You Done To Your 3rd Gen Today?

Is this what you are asking: http://www.rdjtrucks.com/Toyota-Tacoma-16-18-RDJ-PRO-OFFROAD-Fender-Flares-p/10-6010-16.htm then click Tech Specs.

 

Finally installed the Waterport and ordered the Prinsu

 

Can that sit any lower on the bedrails so that a cover can still close?

 

I'm sure you could. You'd have to figure out a bracket that would lower it. I had to use spacers so it'd work with a shell.

 

Love my drake qr mount

 

Very nice covers. Your wife did really well !!!!!

 

Drove it 5 hours to a wheeling/camping meet




Patiently waiting on everyone else lol

 

It was black satin Rust-Oleum. I've used it before on some of my outdoor metal chairs a few years ago and it has held up great! (no, that's not how long I had this can tho). lol

Definitely search through the Inferno thread...LOTS of them have black wheels in there and they look good.

 

Me too!

 

New wheels installed... kind of almost feel like I need bigger tires now, lol.

 

purchased new parts direct and sent in the old parts for a refund.

 

Hahaha. I just installed mine and was pissed they didn’t send spacers. I used farrel nuts from compression fittings because I’m a redneck and also upped the bolt size on the mount to 3/8” and added some studs to the bottom that wedge against the bed for added support. There is no way that bed rail is sturdy enough to hold that with 4 gallons of water in it. Something will give over time.
Waterport later told me I could have used 1/2 of one of the bar mounts on the bottom to press against the bedside to relief some of the stress but I haven’t tried it.


Also I put a Prinsu on last week. Tepui RTT goes on Saturday with @caliraised bedstiffeners.

 

That's funny I literally did the bottom the exact same way for support.

What shell do you have? I'm getting ready to buy a rtt as well but was putting above the cab because I don't want to crack the shell.

 

DMV said my new plates are in the mail. Now considering changing blue grille letters out for yellow. Opinions welcome (picture is just pencil colored letters)

 

Installed a fairly stealth dashcam

 

These went on today. Very happy with the way it rides.

 

ARE V series. I haven’t had a tent on it yet but I have seen people who do. I think it will be fine considering half of the weight will be supported by the ladder once you’re in the tent. I did stand on the roof of the cap once on the Prinsu and jump up and down a little. I weigh about 210ish. Didn’t hear and snaps, pops or cracks.
I am going to support the bed sides though with the stiffeners for just an added security.

 

Hummm. Where to mount this?

 

Would make a bad-ass and useful belt buckle. Hands-free convenience and ready availability.

 

Put on predator steps