Wiring help

Got two midnight pro rigid lights for bull bar want to know how I can hook them up to my high beams. Want to accomplish delete high beam replace them with the rigid industries and stop fogs from turning off when I turn on high beams. Any help greatly appreciated.

 

https://www.tacomaworld.com/threads/cheap-free-mods.4838/#post-45430


And install a relay, using the highbeam wire as a trigger to your rigids.

I did this along with an interior switch so i can use my highbeams and not a lightbar for highway use when needed, or arm the lightbar with the switch, and use it with highbeams by flipping the stalk forward/back as usual.

 

I want to delete high beams all together and use light bar switch to operate the rigid lights. I installed Phillips led lights both headlight and fog lights but when I swap to high beams the beam is way too high not on road and fogs cut off I'm getting more light from using low beams and fogs rather than high. I figured I would use rigid for high beams while using fog lights. Now I'm thinking if I put rigid on high I won't have my low beam on? I was wanting low beams fog lights and rigid on at same time and rigids turned on by my light bar switch. Hope that makes sense.

 

The fault is your led headlight bulbs no?
Throw halogens back in and save money?

 

If you do that "fog light any time mod" that solves the issue of your fog lights turning off when high beams go on.