What have you done to your Tacoma today? 1st Gen Edition

Whatcha after Heads?

 

Timing belt Water pump valve cover gaskets spark plugs wires all the front bearings and seals intake gaskets. Pcv.

Just doing maintenance. 209k on the motor.

 

Oh and new radiator tranny cooler thermostat fender head lights and bumper

 

Should be done by tomorrow eh?

 

I just bought some for my 02 a few months back and payed 1,100.00

 

Love the white led. It would hurt my eyes at night tho

Whoa! Resi's??? How much did that run

 

Washed it, vacuumed, and chased down some interior rattles. Also threw some offbrand sound deadener (duct insulation) under the carpet in the footwells.

 

Did that stop the dash squeak up there??? My car does the same thing in that corner

 

Installed my rear tow harness and replaced all the clips that hold the harness to the bed. The tow harness has been removed since the bed replacement. It's all nice and tidy now

 

Has anyone put a Pistol Grip shifter on one of the autos?
Like this?



I really wanna do something like this in mine

 

Looks like a knife handle

 

Haven't taken it out yet. I would think so because usually I shove a rag down there and it goes away. Will update after I drive it for a few days.

 

Truck hit 120,000 miles the other day so had to treat her to some new shoes. Cooper ST Maxx 305/70/16

 

I have this annoying as fuck rattle in each of my front doors. Tried tightening the wind tracks on both sides but that didn’t make anything better. I think it’s the window glass causing it but I don’t know how to dampen it.

 

How's the weather stripping?

 

The exterior ones? Just replaced it last year since the rubber was flaking off. It happens when the windows are opened and closed. Happens more when they are closed.

 

I pulled the panels and packed my doors with some generic soumd deading material, no rattle and made my door speakers sound better when at higher volumes

 

Alright guys having a bit of trouble...

The center pin on my dakars is about 2 inches too far forward and I can't get it to line up if I center it...I know I got the right part # leaf springs, am I missing something?

 

Last time I tried putting leafs on I couldn’t just put the axel in place, it took a fair bit of work by jacking the leag spring up and lowering the axel to find the spot where they line up.

 

Should I line up the center pin in it's hole first and then connect the front/back of the leaf springs to their hangars?