TTC ☆ OFFICIAL

Just.......NOOOOOOOOOOOOOOOOOOOOOOO!!!!!!!!!!!!!!!!!!!!!!!!!!!!

 

Those are nice. Time for a build thread

 

Bout to start in deed

 

Pass side can be a bitch to get out, you need to bend the inner fender area to make enough space for the bolt to slide out, also remember to pull the wire loom along this area loose so you can slide the bolt out. The driver side is much easier to get out, still need to loosen the wire loom along there so it will clear.

 

Thanks! I forgot about the wire loom got to find my step ladder as well . 5’8” problems

 

Lol, get you one of those two foot ladders...

 

And...! Its going to start right at 610 and 290
When you look out of your window. You will see my truck blocking traffic.. lol

 

What crappening people. I go get my staples taken out Wednesday !! And then they will give my the go ahead to drive and start "lightly" using my knee. Header install Thursday !!!

 

dammit, taking the ubercopter from the roof then.............

 

I need to swap in my SPC's, and the fender well flaps from FS here & also do LBJ's and new bamaguy hubs already on hand.........trying to hold off until wheel bearings are truly done and do all at same time. Just got new tires and they said no issues with wheel bearings, was just balding tires making strange road noise. At 180k miles.....guess we'll see if clutch mstr/slv cylinder swap / complete brake system fluid swap/bleed or wheel bearings demand attention first.

 

Also Going through all my stuff (moving / separation )Btw anything I sell on TW ,
TTC members can have for half of asking if not more I’ll be posting in the Texas Classified

 

Ha nope

 

Is this where it goes?

 

It's a damn good spot for it!!!

 

hear ya there........

 

Got the faux pro grill installed dang bumper hoop covers half.

 

That dang hoop!
Guess you'll have to take the bumper off and sell it to me.

 

If I ever decide to let it go you got first dibs the front stock one is spoken for now.

 

Getting close to beer thirty for yall!!!