Custom Fuse cover- Extended Height

Fuse covers in stock as of 10:30PST

 

Ordered! Thanks @mesojdm

 

Yay!!! Ordered along with The GASSHOLE Fuel Cap holder. Thanks Meso

 

Got one of these too! Thanks! Now I’m just patiently awaiting the taillights.

 

Received and installed! Easier to put on and take off then OEM one!

 

Just ordered fuse cover and a GASSHOLE
Thank You Meso!

 

Question, i got mine and was hoping it would clear my fuse tap, but it doesn't. I ordered this before getting under there and looking at the dimensions, the height is fine but it's not wide enough. Any thoughts? Here's a pic. I didn't realize the under dash fuses were the low profile ones (PITA to remove). Not sure if they make a smaller fuse tap.

 

“It’s not wide enough”
Is it hitting the fuse holder itself(right side in your picture) or the power wire coming off the left?

The fuse cover has notches in the side, you have to pop out the corresponding slot so the wire can pass through and have clearance.

 

just what I have been looking for to install my dash cam setup. Your mods are top notch

 

I couldn't find a fuse that is ignition on that i had a corresponding normal fuse for that would fit in the tap. so there's not enough room where the tap is for the power wire to make it's way out one of the slots.

In this case i used the airbag fuse as i knew that was on only when the ignition was on. i also tested the sunroof fuse which also worked but there was no way the cover would fit using that location.

 

I'm going to try using the IG1-2 fuse instead. That may line up better.

 

You should be able to bend the wire to make it fit. Mine wire doesn’t exit the fuse holder directly next to the add a fuse either, I bent it to a 90 degree angle and had it exit in a different location.

 

Amazing work as always @mesojdm

 

Sold out again... Meso why do you do this to me!?!?!?

 

More manana

 

yeah, this would work so much better if it was half an inch wider. the slots only line up with certain spots on the fuse panel. not sure if others are just cramming and pinching the fuse tap in there but i don't want to ruin mine.

let me clarify that the piece is top notch quality and i have no complaints besides the clearance. there is plenty of open space on each side of the fuse block to allow the cover to be 5-10mm wider on the door side and maybe 5mm wider on the column side allowing for more room for a fuse tap or multiple fuse taps without pinching wires.

as it is designed now, i'm not using the cover for that reason. if you do a v3 that is wider i'll buy it.

Thanks.

 

Sold out again already, or has the restock not hit yet?

 

I’ll update tomorrow. Didn’t have time to grab them today

 

I will have to keep my eye on this thread...if I wasn't to lazy to just 3D print one.....

 

Watching this.
Keep missing out.