PrInSu Design Studio Roof Racks BS Thread

that would make the difference. I emptied the box but i will check again, to make sure i didnt miss anything.

 

do you guys sell the trim separately? Mine disintegrated on my first install attempt and was unusable.

 

Yes we can you will just have to give us a call to order

 

okay cool. Meant to ask you guys about it at expo but got hung up in my booth and forgot. Will give you guys a call this week.........

 

I sent a message to you through the website last week but no reply. Musta been busy at Expo. I don't see where to add the wind noise seal to an order. Is that an option or just get door seal Sondheim?

Thanks

 

http://www.prinsudesignstudio.com/product-page/noise-reducing-edge-trim

 

Great, Thanks,

 

Had the same issue with the load panels on my TopRac. The long trim pieces went on easy enough sliding into the cross bars, but the little side trim (hehe) didn't want to go into the slots on the parallel bars so i just left them off altogether.

 

Any Memorial Day savings/deals on the Prinsu roof rack for a 3rd gen double cab?

 

The trim was broken when opened the box to look. That along with my rack side panels being scratched to hell upon arrival makes me a little disappointed.

Package your items better. Shouldn’t be spending $900+ and receiving them scratched.

 

Ended up cutting 5/16" off each foot (angle grinder)
Smoothing them out (bench grinder)
Primed and painted matte black premium rusto.
Going on the roof as soon as I get a hand.
Concerned that the rack alone probably uses about 1/3 of the weight the LEER shell is rated to hold but no turning back now.

 

Finally got better pic of the racks with the new feet on the toprac. Everything lined up much better now!

 

#10,000 in thread post! - had to do it... lol

 

Ordered mine today with a 40” cutout. Now to get a light bar ... anyone use KC flex?

Also debating if I should vinyl wrap the roof so I don’t have to worry about waxing between the rails ... seems like a 50/50 split on this thread

 

Removing the rails to wax isn't difficult at all. I can get mine off/on in about 7-8 min with my 1/4" impact. I'd go that route vs the wrap

 

I’ve done a lot of reading on this thread. Tried randomly about 150 pages while watching the Rockets fall apart against the warriors. Anybody have this on a Double Cab with a sun roof? Any issues?

Thanks in advance.

 

In the upper right, you'll see the search function. You can check "Search this thread only" which is super duper helpful for large threads like this! Anywho, you won't run into issues with your sunroof.

https://www.tacomaworld.com/threads...racks-bs-thread.317754/page-479#post-17162139

 

Im planning on doing the same. I hsve read that some people just leave a little bigger gap in the cross bars over the sunroof and if they need to, just put them back for heavier loads. I'm looking for the OEM Gutter seals first since I have the OEM rack.

 

Thanks. Very helpful tip. You can see by all my posts, I’m not too experienced on the site.

 

Not a problem! That's why I shared how I got the info, rather than just stating that it'll work with a sunroof. Figured it'd help out.