2016-2019 Toyota Tacoma Fog Light Mod! (Step by Step Picture Heavy)

So i found some trd fog lights and bezels from craigslist for 60 dollars. What else will i need. Will they connect with the oem lights? All the stuff that moe linked?

 

Basically the trd fog lights are brand new for 60.00. With bezels. Is this a good deal? If so can i get a some other part numbers i need to finish the job please. @moe2o4

 

Im almost 100 percent sure im not prewired. Ill have to double check but its a base sr i4. Just wondering whats this all going to cost past the 60 im going to spend.

 

Thanks for the detailed write up! One question though. You mentioned that you fused tapped it to the 10 amp ignition which is what i did and you explained it was because when the car turns off the fog lights will turn off also. My question is if i forget to push the button to turn off the fogs even though the lights turn off will it drain my battery with the button still pushed in? I know this sounds stupid lol. Just asking.

 

No, it will not drain the battery if the fog light switch is pushed in and the ignition is turned off.

 

Awesome wite up OP, can't wait to install them!
Has anyone installed the fogs that come with the kit, or something similar to the kit, and gone through a water crssing where they were submerged? Curious if I need to spend the extra money for some "waterproof" fogs or if these will work well enough without letting water in them. Most trails I hit have water crossings in the Spring from all the snow runoff. Thanks!!

 

Does anyone know if the 2018 SR 2.7l 4 door 2wd are prewired for fog lights?

 

Do you know If you have the convenience package?

If so - you should be prewired I believe.

 

On the paper that shows all the details it says “SR Convenience Package”

 

It’s actually pretty easy to pop the top cover off the steering cover to check for pre-wiring.
Just check out the picks at the beginning of this thread.

Regards

 

Thank you @moe2o4

 

You're welcome @brodys16sr! Anytime!

 

Thank you @moe2o4! Put mine in on my 2018 SR earlier this afternoon.

 

Which wiring harness did you guys go with?I'm seeing negative reviews on the one from Amazon with claims of it not staying snug and popping out, most of the reviews were from Ford owners but I did see a few toyota owners in the negative review section as well.
Thanks in advance!

Edit: also I was researching the button itself that comes with the winjet kit apparently gets hot to the touch after 10 minutes or so, I'm curious if there is another button I could buy seperatley that will fit the bottom left blank slot next to my ect button that is close to the oem blue back lights on the other buttons.

 

I went with OEM parts, except for the switch itself. You might pay more for OEM, but everything fits and is compatible with existing apparatus.

 

Add a circuit

good to know, thanks for the reply, any links to where you bought yours from would be greatly appreciated.!

 

I got everything from forum member gunni1005/Gary @ Camelback. Search for Gunni1005 and shoot him a PM. He sent me all the correct parts, including the Intermittent Wiper Stalk. He beat the prices of my local Toyota dealer. Good luck

 

Nice thanks for the info i have actually gotten quotes from him, I wasnt going to go the stock route though, i definitely wanted the button down by the auto headlights button to the right

 

Hate to bump an old thread but. I have the sr convenience package. Am I pre wired for fogs?. If so, what do I need to buy to install them?

 

Updated a few links on the install and made sure everything works! Updated the fog light switch. I got mine from Air on Board which has just about every switch under the sun!