What Have You Done To Your 2nd Gen Tacoma Today?

Had both U-joints replaced, was getting light vibrations at almost any speed, expected wear and tear.

I also refurbished an old oil can for my gas can, I dislike just about all fuel cans on the market , and it’s not the most convenient thing dealing with a full 5 gallon gas container of any sort. I figured 2 / 1 gallon cans (and a funnel) is all I really need.

 

nice job ^^

 

That plastic clip came with the holster, I just anchored it with the hardware to keepit from bending when it has the Glock in it.

The end of the clip there’s that edge that comes out catches on something on the plastic underneath the steering wheel and the thickness of the clip is enough to keep it snug

 

Where'd you get that flag sticker?

 

Gave it a much needed bath and parked in the garage while my daughter is out of town.

 

Driving the Camry to Lexington KY tomorrow for a flight to ft Lauder-dale FL, step dad finally got a heart transplant...was really stoked about a mini road trip in the taco but I suspect a ball joint going bad so I don't wanna risk it until I can get back and check it out. Sounds like a creak and squeak right in the uca when the truck moves what so ever anyone got any thoughts?

 

I was still rubbing my cab mount after a cmc, so I cut a bit more. Was a pain to make the cut, but it is what it is.

 

Solid work!

 

What tire size you running these days? I remember you 285s last or you were selling them I think it was?

 

I had the pizza cutters (255/80r17) but have since went to 295/70r17!

 

If you are super picky about swirl marks and stuff always make sure to wash in straight lines, and use the two bucket method.

 

Ordered off of Amazon

 

I replaced my rotors today. Lucky I had a couple m8-1.25 bolts laying around to get the passenger side off.

Also I strapped down these 4 Husky 25gal totes, and they fit perfectly in the back. I bought 10 t-slot nuts, bolts and d-rings for the side rails. I really like how the back is looking, next is an axe an shovel mount.

 

Did the u joint replacement fix the vibration issue ?

 

Hope the trip goes well

 

Is that OEM or after-market?

 

All I need is my sPOD and I can begin operations...

 

That's gonna be a niiice #FrontEndFriday post right there!

 

Where'd you get the D-rings and hardware? I'd like to pick some up.

 

Inspected everything for my 100k service, now time for fluid changes, grease, and new suspension parts