What Have You Done To Your 2nd Gen Tacoma Today?

Is there a DIY writeup on the UNI Filter?

 

I think, but all I did was remove the top screw with a T-25 torx driver, remove cover, remove foam filter, remove the end cap and slide on UNI filter, tighten filter clamp, then reinstall.

 

You need to remove the foam filter under the cover also.

Read this thread:
https://www.tacomaworld.com/threads...you-own-a-tacoma-you-should-read-this.449563/

 

Roger that. Thanks!

 

Taking the end cap off the cover is the hard part! There’s four plastic clips holding it on, so use a flat head screwdriver to slowly work it off. Get one clip over the shoulder, then move to the next one.

 

Took my lunch break to run down to the garage (working from home today) and wire wheeled, acetone wiped and primed my BAMF LCA skids. I'll see if I can find some time this afternoon to go shoot them with color.

 

Good.
I have the same. Redline Tuning for the hood works great; comfortable.
Have the UNI filter too. (just wondering why this little filter remains always clean, even in dusty conditions...)

 

Your nuts relying on this little boards on top of the jack stands. They could slip so easy. Why not just jack up under the rear axle, so the suspension doesn't fully extend, & put your stands there?

 

The hood is so much easier to open and close! Took about two hours to install both, but I was taking my time and double checking everything. Took about 10 minutes to get that stupid end cap off the pump cover. Didn’t want to break it!

 

Yeah, put those jack stands under the axle.

 

How did you do this?

 

I just ordered 35s...

 

35s or 315s? What type?

 

35x12.5x17.

Treadwright Guard Dogs.

 

How much are those a tire?

 

175$. I landed 5 for $795 with a discount code.

 

Smooth. Nice score!

 

super pumped, gonna be big as hell compared to what I'm used to haha!

 

You got a link or brand name? I need to start buying plywood for my attic. I once put up 4x8x3/4in MDF up on the back of my cab and the ratchet straps sunk in my shark fin antenna Had to pull the dent out then silicone seal my antenna back to the truck lmao

 

It's next on my list of mods for the truck. Thanks for the reply