What Have You Done To Your 3rd Gen Today?

can ya show a pic of it installed?

 

Came out more low key than I thought t would, which I’m cool with. Cost $14

 

Thank you for sharing...

 

I will take that later today. Ended up working on the other side of the island and I’m still babying her on her miles hehe she’s still under 1200 miles lol!

 

Does anyone have a recommendation for a good affordable air compressor? I plan to invest in an ARB on-board air later on but I would like to have something now in the meantime.

 

Viair 88P. I have the 85P and it works well but I do wish I'd gone just slightly bigger to speed it up a little.

$75 VIAIR 88P - 00088 Tire Inflator Portable Onroad/Offroad Air Compressor for Car, Truck, SUV & RV | 12V On/Off Road Tire Pump Air Compressor Portable Heavy Duty 120 PSI, Alligator Clips, Twist Chuck

https://www.amazon.com/Viair-00088-88P-Portable-Compressor/dp/B005ASY23I

 

Drove mine through a tunnel.

 

While it's a nice pic, that's not a third gen...anything. As F-150s go, that's like a 7th or 8th gen.

 

Here:

https://www.f150forum.com

You're welcome.

 

yea I guess so. Looked more like bottle opener but I can see the T now that you guys point it out. Didn’t know if there was a story behind it

 

I think it came out when the tundra got big. 2007 maybe? I think it was their marketing campaign to go up against the big 3. I haven't seen much marketing around the Tacoma with it, but maybe it's popping up more.

 

Finally got bed rack. Now waiting for Prinsu and headlights.

 

i've been eyeing this for a while. i think you've convinced me to pull the trigger.

 

DOHH!

 

Uh oh...

This is not good.

Amazon.com Locker Pickup Code
PICKUP CODE: 666666

 

Installed noico sound deadender in the doors

 

I'm getting ready to install some as well when I change the door speakers. I'm wondering if you read the noico directions, and if it said that you needed a roller to roll the mat once you apply it, as a necessary step for the mat to work right. The stuff I bought said that, so I bought a roller to do so, but I haven't seen anyone on here talking about rolling it. Also, it says that the embossing on the backing will be flat after you've rolled it properly, and that's how you'll know it was done right, and I haven't seen any of the other members photos where the embossing was flattened so I'm assuming people are skipping this step

 

Does this make a big difference? Or a speaker upgrade would be worth doing it with this?