Alabama thread!

So is yours holding up better than all these individuals calling them a

Char-Broil Oklahoma Joe's Charcoal/LP Gas/Smoker Combo

rust bucket.

 

B110s have been my plan for now

 

My welding friend says Steel Supply on meridian street.

 

Awesome. I'll check them out. I also have a buddy of mine who recommended Limestone Steel Supply out of Athens. Apparently they sell the leftovers from cuts for a decent discount.

 

Mine is fine. I also bought the heavy cover from them with it and take care of mine. I'm not sure where your located but the Charbroil outlet at their old factory in Columbus is where I got mine. They are $429 everywhere else for just the smoker. I got mine in the box with Oklahoma Joe's cover, a charcoal chimney, 3 bags of chunks, wireless thermometer and 2 bags of charcoal for $311

I did get a public safety discount though of 10%.

The smoker there is $350 assembled. Much cheaper if you put it together yourself plus you can seal it up good doing it yourself.

 

Another rough day on vacation.

 

The bumps catch about 1/2” before I bottom out the Kings. I couldn’t get the nuts on the bumps with any size spacer. Just not enough thread.

 

A & J Steel in Snead. I get scrap from work to practice with if you need any I could probably get some. I just bought a Lincoln pro mig welder a few months ago. Trying to get back in the swing of things for work.

 

You said yours were setup like mine?

Use washers?

 

Dang good deal! I like. Mine is getting on its last legs and wife wanted a smoker on the end when we get a new one. So is the outlet in Columbus (?) still around? I'm in Huntsville, AL.

 

After I drilled the hole and put the bolt through the frame there was barely enough threads to get the nut on. No washers. Sorry pics suck.

 

Columbus, GA. Home of Charbroil who bought Oklahoma Joe years ago. Yes it's right across the street from their main warehouse on Belfast Ave.

It's the Building that has the black roof on the left at the end of Belfast Ave @ Concord. Has the red X on it. I believe they are only open Mon-Fri though.

 

Gotcha. Mine are not on the frame. They are further out on the original bump stop strike pad. It’s thinner than the frame itself. Would have to have the flip kit that has the extended lip for hydraulic bumps to be able to do it the way I did though.

 

Always been on sewer I don't know.

 

Time for a 14 hour shift and then a 7am shift tomorrow, fun

 

Sounds awful, glad i am off today and going to the beach tomorrow. *wipes sweat from brow* its gonna be tough.

 

HAHA! I hope it rains! lol
































*Disclaimer, the above is said with raw anger and jealousy!

 

Oh its gonna rain, but I would rather get rained on at the beach than at work.