NW WA Meet / BS Thread

And you risk blood poisoning too

 

This why we train in self recovery.

 

Maybe your AMR,falk or rural metro ambulance won't have it or use it. But I would bet my life that every municipal rig wil, he'll even SPD carries them.

 

When I'm not quite so busy I will link the science. But regardless of what anyone or anything says, when your out in the middle of nowhere!

 

The municipal shit I did, we didnt carry them. We trained pressure points instead. We did know how and when to use them though. The reasoning from that particular PA was that a bp cuff could be used for the same thing.

 

hawt. Thanks home slice

 

https://www.ems.gov/pdf/research/St...s_Of_Tourniquest_And_Hemostatic_Dressings.pdf

 

https://www.wemjournal.org/article/S1080-6032(16)30285-X/pdf

 

I picked up the Tacoma Attic a while ago and have been really happy with it. I wanted a spot to stuff flannels and sweatshirts so I could easily get to them without digging through my work gear.

 

Does anyone in the Renton/Kent area or maybe even Auburn/Pyallup areas have a decent bearing puller I could borrow for the weekend?
One of either of these types:

 

Oreilly’s rents those out pretty cheap

 

Cool, thanks.

 

has anyone used their stock fog light switch and wiring to a Rigid or Baja fog light? I think the LED fogs use a deutsch connector and this adapter would work?

$35 Starkey Products Fog Light Wiring Adapters H11 to Deutsch Set

https://www.amazon.com/dp/B01EXWDNT...olid=2KGUDUL886CG0&psc=0&ref_=lv_ov_lig_dp_it

edit: @JimSnell you asked why the fog light tabs were angled down. There are two L brackets for it. Not sure why though. Maybe so you can adjust up-down and in-out?

 

Not rigid or baja, I’ve got Cali raised that are wired into the stock fog light switch.
Those look like the same adapters Cali raised sends you to make them work with the stock plug. I can check when I get home.

 

I would have got those connections if I had known about them. I just cut off the ends of the factory harness and soldered in my LED fogs.

On another note mine did end up interfering with certain FM radio frequencies when turned on because the stock harness doesn't use shielded wiring but doesn't bother me enough to do sth about it

 

Does anybody know of a shop in the Puget Sound area that will do a cab mount chop? That will also supply the new plate?

Mule is booked out until August for labor, or else I’d drop it off there.

 

@JimSnell

 

after studying pictures and looking at my stock fogs I believe I purchased the right stuff.

https://www.youtube.com/watch?v=tbIEwIwYz-c

 

I

I wired in my ditch lights to the factory switch. I may or may not have another set of plug ends. I'll check when I get home.

 

I

I wired in my ditch lights to the factory switch. I may or may not have another set of plug ends. I'll check when I get home.