1st Gen Lunchtable Thread - General Discussion

I didn't ship it yet, but I got quotes for LTL pallet shipments. I use Grayhound Bus Lines a lot, and there's pallet shippers like Forward Air and freight brokers like Shipnex or uShip.

Grayhound is the best way to ship rims. It's very cheap, you just have to pick up at your local bus station.

 

Go sit in a Lexus ES300.

I sat in a loooooooot of seats before I chose those ultimately. From Mercedes, to BMW, to Subaru, to Ford. Nothing beat those memory foam ES300 seats.

Besides a 80's Cadillac DeVille bench seat, which is basically a bed.

 

I’m really tempted to try and get a 4Runner awd transfer case and get it working in the taco.. awd and low high range 4wd in a high power Tacoma just makes me so happy. Lol

 

Do it! Center diff lock too.

 

Gotta get the engine done first.
And the frame swapped..
And the body work..
hell this thing will never be done

 

Same here. The end is not in sight.

 

Limited seats are nice i dont blame you for wanting some lol

Hmm might need to look into this, ik a guy in flordia wanting to buy my s runner rims with the tires mounted on them.

 

My poor truck has been down for 2 years now. Sad thing is everyone that was following my build thread probably thinks it’ll never be done... I’m Litterally just tying to find a damn crate to ft all my engine stuff on to send to lce. Frame is one it’s way already (2-3 months probably) and the body work will be done when I get the engine back.

 

My trucks wired for the seats too. So it’s just bolt ina And plug in

 

That won't be cheap. Grayhound is only good for local-ish deals. Like Pheonix to San Francisco.

You can try though: www.busfreighter.com

 

You got a frame replacement?

 

It’s been replaced. But the jackass that did it ruined the current one.. I got Toyota to front half the bill on a new one I’ll put in

 

Why not just build the create. Its not that hard... we do it all the time for my dads company

 

My parts department loves me...

New frame.
New heads.
New doors (fronts)
New tailgate
New fenders.
I’m a little crazy. But discounts

 

Nice. How did they mess it up?

I was just reading through your build thread. What's the current status on it? That 3VZ crankshaft looked interesting. How is it different from the 5VZ?

 

Going to. Just haven’t had the time. Between my work and side work to pay for the shit I do. I’m usually busy

 

Grayhound works great for light-ish bulky items like tires and bodywork. My transmission is very small, but heavy and I got quoted like $200 to ship it to Minnesota through Grayhound.

 

Forged crank. Much stronger. Can handle 7000rpms if I wanted or a lot of boost

 

This is rough, don’t question the way it’s loaded.

 

Uh...

That looks safe.