Austin Area TW Chapter (all gens welcome, even T4Rs; heck, just make it a Toyota and we're good)

Icon? What size spring? 650# x 13"?

 

That’s weird you having that much trouble what size spacer you looking for?

 

@Texoma sent you a PM good sir!

 

Yes ICON with 650# x 13"

 

Replied

 

Sold buuuddy, more lift on ChadsRide?

 

this is a whole nother level

 

Yes sir! Hopefully take it to a good stoppif point for a while.

 

Max thread showing is 2.13". I suggest that on driver side and 1.85"-1.95" on passenger side.

 

Check out Bora wheel spacers. You can do 3/4" spacers. FYI, you may need to cut the studs down on the spacers so your lug nuts don't bottom out and strip the spacer.

 

Alright that sounds good. Got a set on 1.25" spidertrax in the works.

 

Not sure about how thick yet.

It was about 3/4" lower and 4 turns evened it out. I believe I read somewhere that 1/4" spacer gives 1/2" of lift and 1/2" spacer gives about 1".
If that's the case I will go with 1/4" and use the adjuster to even it out.

 

Just measured and I'm about 1.25"on passenger and 1.75 on driver.

I still don't have UCAs installed, think I'm safe to max them out to your recommendations or leave them alone for now? I will be getting a new alignment within the next week and would prefer to not cause significant tire wear on the trip.

 

They can be maxed. Extended travel shocks all require aftermarket UCA's, so be sure yours are not ext travel.

 

Anybody running 6112s or have any knowledge about them ,@Texoma i am sure you can chime in on this .

 

What you need to know?

 

Do they reall perform that well and are you going to get that much lift after settling in on 5th notch .

 

Yes

 

Just as a data point. I have the 3/4" Bora's on mine, for about 3 years now, with no problems. Yes, you do need to watch out as the stock lugs poke out of the spacer. As such, the wheels need "pockets" between the lug holes, or the lugs need to be trimmed off some. Anything over a 3/4" spacer should be no problem.

 

They will perform great overall diameter is 60mm which equates to 2.36in thick. That’s just shy under a coilover thickness have rode in a T4R an a taco with the trdpro setup which is similar to 6112 I believe different valving was a butter smooth ride on both accounts.