What Have You Done To Your 2nd Gen Tacoma Today?

Got one on my '15 2.7 DCSBPR

 

Your back and legs will thank you. I also like the better vision over that hood.

 

I found a company that professed to have a delete mod for it. Through email they sounded really wishy washy. There's a market for this if someone is brave enough to make it.

 

weird, my 2012 TRD sport does.

is yours 4x4? Mine is...

 

Been looking at these. How’s the output? I like them but I don’t because hids will ruin the projector

 

Finally mounted up my Ditch Light Brackets and threw some KC Flex singles on them! Not sure if I should have gone with the duals or not, but I really like these!

 

Thanks for helping out with my camera issue..

 

Just swapped out my branding iron. After sitting in the sun all day the buckmark will leave welts. Same old shirt has done a lot of coverage.

 

08 4x4 prerunner double cab trd

 

I had one on my ‘13 2.7 and did the mod

 

You all are having way too much fun. Me? Bought a 2010 A/C July 7. Ordered parts and hit the auto supply store. July 15 I replaced the rear tail lamp (cracked and collecting water), right tail gate strap (missing), wipers (I think they were installed by Mr. Bosch himself), engine air filter, cabin air filter (had to cut down the old-growth forest that has sprouted up), mounted the right mudflaps (torn off during an off-road attempt I guess), and I picked up some CoverKing neoprene seat covers. Sources? RockAuto, Autozone, Craigslist. Cost? $174 total.

 

Made a stainless mount for that dead space behind the fuse box. Got my

$310 ckma12 on-board air compressor high performance 12 volt for air locker differentials and tire inflation

ckma12 arriving today. Gonna make a compressor/ fuse panel. Hopefully this setup will work???!!!

 

Welcome to tw.

 

It seems have some strength , but I didn't take care enough while working.
As you can see, the tailgate has become about 1/2 inch lower on this side.
Moreover the left bed wall gegins to give way on the left.
So, I've ordered bed stiffeners; hope it'll help to put that right again.

 

Yes it does. I've swapped mine already....

 

I'm watching you

 

For sure. Work in progress. Take it back to the truck, measure and lay out the holes for the mount and compressor and hopefully have it mounted up this weekend. Stay tuned

 

I just learned bend radius and setback so I am eager to bend some aluminum at my school to use as my OBA and Aux fuse bay/WTF is that area...

 

That is a lot of weight for a panel like that if you are going down even gravel roads. Might want to fab a support leg that bolts to somewhere in the engine bay. Powertrays use a leg like I described. Maybe take some inspiriation from those.