Air box mod

Cant imagine it will do much of anything, there was a dyno test on here where they removed the filter and there was no gain.

 

sorry but that looks like a hack job. you used aluminum dryer vent.

 

or try a snorkel to suck air from outside?

 

OK,you do it your way

 

And now the end is near...

 

why not cold air intake?

 

Is this not what has been achieved as rough as it is. Come on, cut the guy some slack.

 

This basically is just adding more foreline to the stock intake vacuum system. Without going into too much detail, at best is will have no appreciable gain on air movement, at worst it will actually result in a lower intake velocity and result in less air movement. No way to know without measuring devices, but I'm confident in believing it has essentially no affect.

 

no because he most likely using the oem filter add that hole/hose will do nothing

 

Opinions are like assholes, everyone has one

 

could this be another cruel 3rd GEN hoax??

 

will that pass CA emissions check?

 

honestly its hard to believe someone would do this to a $45k truck it boggles the mind

 

This can't be serious

 

BRB. Not going to do this to my truck.

 

I think the most gain, if any, would be seen in smoothing out the airflow after the filter where there is more bends to flow around. Doubling the amount of available inlet air to the filter box probably wouldn’t do much, but maybe a slight decrease in intake air temp here? I wouldn’t hack up a stock air box to try this on my truck.

Anyone looking for a used AFE intake with scoop? Lol

 

If you paid 45k for your truck they saw you coming and screwed you good

 

There are opinions and then there are facts, thermodynamics, quantitative data, etc