1st Gen Lunchtable Thread - General Discussion

Just roll cage and 5 point harness and delete the air bag lol

 

Haha if it was a wheeler and not a daily

 

who says you cant have that in a DD

 

Fair enough haha, I want an old sas'd Toyota like that

 

I always wanted to get roll cage in but i have no need for a exo cage and i dont like how they take up space inside.
Want to go full custom and hid it under the interior trim

 

That sounds like money, that's the main reason I wouldn't want one in a daily, take up space and gotta cut up more shit then I'd want to.
And honestly I've been in a few rollovers (one in a Toyota) and they've held up good enough for me to not worry about it unless I was doing something crazy

 

Huh.

 

Tacoma is now a gender you can identify as, don't judge

 

Must be a 3rd jen thing

 

Yeah I don’t ever do anything crazy enough to worry about needing a roll cage. But the day this truck is no longer my dd all kinds of crazy shit gunna happen

 

Here’s the thicc frame crossmembers leftover from the fifth wheel hitch on the 5-lug. What’s the best way to remove it, just angle grinder with a grinding disk on the welds?

 

Tourch it off

 

I was about to buy an Oxy-Acetelyne torch when my friend was scrapping his Ford Ranger cab and frame. Just never ended up buying one.

All I have is an angle grinder.

 

I have one

 

I’m never going to make it that far, I can barely make it out of my driveway.

 

You need AAA lol
Or i can see about bringing it there lol.
But i dont see why you cant just angel grind it off or use a air hammer and chisel it off

 

@BartMaster1234 you might as well c notch whille you at it if your gunna lower it lol http://stores.streetacos.com/notch-kit-c-bolt-on-95-5-04-tacoma-5-lug/

 

just angle grinder. then paint over exposed metal... if theres no weld across the tops of the plates, throw a bead to keep water from getting between those plates and the frame.

 

Oh I wanted to just remove them completely. I’ll try grinding the welds off and painting over it with some POR15 I have leftover.

 

oh to remove them completely just cut away at the welds and the plate should be able to be chiseled off. then grind the surface flat and hit er with paint