What have you done to your Tacoma today? 1st Gen Edition

They got a fresh 4runner and i saw another taco sitting at the yard.... grabbed some parts to swap my wheel to a black on and some spare parts from the taco (ecu and gauge cluster)

 

Nothing to the fuse box. I do have an after market alam. I have ditch lights to the battery

 

Installed 4 riv-nuts in the bed to secure the toolbox a tad better. Need to pick up some bolts tomorrow at the store, couldn’t find any in my bolt bucket

 

Something must be keeping the alternator running constantly, or cutting on and off constantly. Def need to locate that draw.

 

I def like.

 

Front end was sitting low with the skids and bumper. Just bumped it up and it’s much better.



Sitting better now

 

So I’m replacing my drive shaft today as it’s worn out( ujoints, slip joint, Cardin joint) from too many miles (570,000)
and I see the brass dust cover behind the flange on the transfer case is loose and spins easily
with nothing holding it in place.

Do I need to replace it or is it ok just spinning, I don’t know the dynamics behind the dust cover.

 

Just got done installing a Shrockworks rear bumper today.

 

details on this?

 

What do you need to know?

 

Leave it on.

 

where did you get it?
Did you design it yourself?

 

I just made it myself this morning. Bent the skidplate mount brackets from 1/4” plate, notched them to fit 1.75” tube and used 3x3x3/16” angle iron for the frame mounts. Couple bends in the tube, weld it and it’s all set. I was originally going to make it a little more complicated, but I settled on this design.

 

More bumper v2 fab in progress today

 

Might be going to a Hi-Lift Trail Fest event at Redbird SRA on Saturday, need to actually put this new armor to use and test this truck out on something other than old gravel roads and short local trails. Didn't realize that Hi-lift was an Indiana born and bred company either which is cool since that's only a few hours from me

 

oooooooOoOoOooo I like what I see

 

Damn I hate electrical so much

 

Started installing a winch only to find out it doesn't really fit too well with the All-Pro bumper ¯\_(ツ)_/¯

The controller doesn't fit on top of the winch so I have to find a place to mount that and it appears the spool lever is pushing up on the grille quite a bit...

 

Clock it forward and put the control box in the engine bay

 

Beat me to that answer lol