Wiring from bed of truck into Cab - Help

Im sure its been covered, but Ive searched and cannot find it, so I'm sorry in advance if this has been answered 200 times.


Im wiring up reverse sensors, and the box the sensors lead to needs to be inside the cab. The wires come from the bumper, up into the tail light section, then through the side of the bed where the little cubbies are, then out a tiny hole at the hop of the bed, right before the cab. Here is where I got stuck, I could not find any hole to wire them through at this point. Any help would be appreciated.

 

There are several rubber plugs/grommets underneath the cab.

 

Welcome to TW. Under the driver's side rocker panel (under the driver's seat area), follow where the emergency brake cable enters the cab. Use that grommet. then pull up the plastic trim that runs along the outer side of the driver's seat floor area and the kick panel. Should clean up nicely.

 

i drilled a hole thru the floor near the rear of the cab and siliconed around the wire

 

these. I ran power wires for back up lights and used one of the little rubber grommet holes. there are a few under there.

 

Appreciate the fast replies... I found another thread with photos of a CB coax cable being wired that helped. Thanks!