What Have You Done To Your 2nd Gen Tacoma Today?

Wired the new winch up today and did the first spool. It was fitting that the 4runner was its first dance partner.

 

Wash, polish and wax, looking good for it’s age

 

How many feet and what diameter of the AmSteel Blue did you fit?

 

85ft of 3/8ths

 

Cool, we sell that in Silver up to 1/2 inch. AmSteel is great rope...

 

Had to rescue one of the big kids out of a very menacing sand dune! No joke multi-snatch recovery in a bad spot.

 

If you need a breather when you get back, come out to Utah! Drive your new toy or I'll pick you up at the airport. I'll buy the first round regardless!

 

Took about 8 hours to tackle my doors. Still left is my roof and floor. Only went through about half of my noico sound deadener for the doors.

Some hightlights from the day.

 

Got The Falken Wildpeak AT3Ws on TRD Pro/Sema 17” Matte Black Wheels

 

Did the uni filter mod. foam was pretty crispy but in one piece. Was anyone else startled at the difference in the sound it makes? Noticeably louder.....for those 30 seconds it runs. Didn't have any trash in it when cover was removed. The sound kinda makes me wonder about putting a fresh piece of foam back in it.

 

Clear coated my ATH bed stiffeners and cleaned/oiled my K&N CAI.

 

Love the wheels and slight poke. Is that 1.75 WS? The truck looks really clean.

 

Looks good man, that's what I did with my front end. How'd your alignment go? They told me I was "on the edge, but should be fine".

 

I did 3 things I took my go kart to go off-roading I did a little bit of wheeling with my truck And I finally added a uni filter

 

Radiator support bushings '014 34k AZ Truck

 

There are other ways around that tpms light

 

Ya trying to avoid cracking open the dash.

 

I did one method where all i did was add a 4” wire and jumped 2 wires together. Light was gone. I also could do it all just looking up under the dash on the passenger side. No dash disassembley at all! The how to is somewhere on this site

 

With a lot of help from another TW member, we spent 6 hours reorganizing the engine bay re-wiring.

From this....




To this.....



It may not look like much, but it was a spaghetti factory in there.

 

I've searched and searched. I found one on another site that required pulling the sensor box and grounding the blue wire the method you mentioned has eluded me. I've got a 2006 DCSB.