1st Gen Lunchtable Thread - General Discussion

As long as its not political were good.
But yes commen sense is lacking in todays society

 

whats common cents?

 

Euros

 

Last minute trail run today...Pilot Rock X trail up to Lake Arrowhead and finished off with a couple beers at their local brewery up there.

These skinny 33s still rub like a motherfucker lol...need to cut the pinch weld off

 

Just tub the cab...

 

Good lord I am

 

My 33's don't rub that bad at all and my front suspension is sagging like crazy, cut that shit off or beat the hell out of it

 

It's the backspacing on my aftermarket wheels I think...only thing that makes sense really. But yeah I just need to trim more and it should take care of it...nothing an angle grinder and cutting wheel can't cure

 

Whats the bs? Dont you want something like 3.5

 

Mine stick out of the fenders more the factory wheels (not sure if that's more or less back spacing, I'm not smart with wheels) but they rub when flexed on the pinch weld area still, but not really bad enough to actually be an issue, it's just an annoyance

 

I rub on my bumper...

 

Yeah mine are fine on the street but once they start to get stuffed offroad or turning into a driveway the outside of the tire smashes against the corner of the cab/pinch weld. I've beaten and smashed it back as much as I can but I think I just need to cut it off now.

 

Honestly I might, I haven't really paid attention since I put the new one on. Unlike you though I have the correct number of lugs

 

No idea. They're aftermarket wheels the PO put on. I like em but even with 31s they rubbed the pinch weld

 

Does it rub on the cab mount?
Maybe time to chop that. Bamf makes plates

 

Yup. Pretty much same place, cutting it off from the get go probably would have been a better move for me then hammering it down

 

My wheels stick out far so i rub on my all pro bumper. I need to with get less bs or chop the bumper. Maybe a different bumper idk

 

Yeah same here...at the time with 31s - 32 I got by fine just bending it back...but now I need to get medieval with a cutting tool

 

Is the BS on those methods the same as the wheels you have now?