Bed Side Rail Cap System - NOW MADE FROM ALUMINUM

In your case, I would stick to the factory caps. They are naturally curvy, like my women.

 

Make no mistake, I'm done and moving on. I have a few thousand dollars worth of other parts to attend to. Somehow.

 

We need to send young Ben thru a 8 yr time warp...instant tool caddy.

 

I have these caps, and I had added 5/8” exterior plywood between the fiberglass and the camper shell’s original gasket. I believe @HomerTaco has done something similar. I also trimmed off nearly an inch of the side overhang of my shell to help with lateral clearence. It all worked out very well. My shell is a Leer.

 

I used 3/4” of HDPE plastic for spacers.

 

Plywood? Not Ipe?

 

Curious if you used any fasteners to mechanically secure the HDPE in some manner, or just rely on the compression/friction of the shell clamps?

 

I had the plywood laying around already. In fairness, my shell cost $40 on craigslist.

 

I ran a couple of counter-sunk stainless steel screws through the top of both sides to keep them in place.

 

Nice. That's pretty much what I was imagining if I were to be bothered.

 

Anyone selling there stock ones for a long bed pm me.

 

Looking at this to load dirt bikes and have more tie off points will it be able to handle that, I imagine it’s only attached to the bed with tape up front? Got a new Tacoma need to sell my 1st gen

 

Price is $180 per set for short bed and $200 per set for long bed, plus shipping. Includes gasket material and T30 Torx bit.

Order directly from our website.

Promo code for short bed is TWSIDERAILSB to save $10 off list.

Promo code for long bed is TWSIDERAILSLB to save $10 off list.

These side rails are 1/8" thick. They sit flat no matter what you do to them and can handle any abuse.

ALL PARTS ARE NOW LASER CUT.