What Have You Done To Your 3rd Gen Today?

Installed the water port. Had to use some half inch spacers and 1 1/2” 5/16th bolts to clear the cap edge. Disregard the nose art done by the dogs on the windows, they think they are freaking Picasso’s, you should see our sliding glass doors, pure masterpiece.

 

Thanks, did it today. Easy job for a lot of clearance.

 

The silver bolt is the one I used to pin the molding. The other bolt is from air dam removal.

You would have to stick your head inside the wheel well to notice the cut. Otherwise undetectable

 

I hear ya......me, too.


Labradors lead the way.....

 

picked up some hondo tslot nuts! way better than the old rusty ones that I had

 

Maybe your bed is covering up "SUB"!
DOHH!

 

I think you got what you were looking for, they don't look objectionable to me. But it's not my ride and in the end you're the one that has to be happy. They work for me. Nice Taco!

 

I appreciate the kind words but not my rig. I was replying to his post about sticking out too far but would work for me.

 

Sure don't look as good as what I usually see settin' there!

 

Looks nice. I think I saw those on the street the other day. Do they have the sequential turn signals?

 

Thanks, yes they are sequential.

https://youtu.be/NjTXSLHcceU

 

If Gregs grillin', I'm in!

 

Looks great! Where did you get them? How much? How is the beam down the road at night of course? High and low beam?

 

Got the TSB 0062-18 done today! Whoop whoop! Many thanks to @cruetes for hooking it up with a knowledgeable service advisor.

 

Oops! Sorry 'bout that! Rough night at work last night, busier than a one legged man in an butt kicking contest. Guess I didn't get enough sleep this mornin'.

 

Got them off ebay

Spyder Auto Part# 9039256

Edit: Here is what was on the box

 

2 months old chipped windshield and my floor mats came in and they forgot the rear section not a good Friday

 

Nothing spectacular. Just dipped the badges and wheel emblems.