What have you done to your Tacoma today? 1st Gen Edition

Maybe the Napa I went to just didn't stock them but it made me wary of buying them anywhere but Toyota...but this is good to know.

 

Yeah not everywhere has a good metric selection. You can get them on McMaster for $6 for a 10 pack. I believe the ones I use are P/N 95735A635

 

Well that's the information I was looking for then. Just depends on when I can get to either Toyota or Ace then. I don't need them for a few days anyways

 

I'm going to say at least 1/8 of the bolts on my truck are from the Metric drawer at Home Depot.

 

I might have a set of new OEM bolts that I got from Toyota that were extra if you want them.

 

Thanks for the offer but I'll just get all new ones together so I don't lose any

 

It's two sets for both LBJ's though.

 

Oh shit if that's the case yeah I'll take em! I thought it was like a few here and a few there. I'll PM ya

 

I've seen them that bad and not in a junk yard.

 

So my truck starts to sputter in the morning when it’s cold then it warms up and goes away.

 

Sputter as in the RPMs dip too low and it struggles to idle?

 

Sputters as it at high idle then gets to temp and idle goes down and sputter goes away.

 

Small vacuum leak somewhere maybe? Any codes?

 

I haven’t checked for leaks yet. And no codes

 

I'd start with the basics...clean the throttle body and MAF sensor if it hasn't been done in awhile, both can cause weird idling issues. Figure a vacuum leak would toss a code if that were the case

 

yeah the gasket on my Dorman handle is my only complaint with it, it is ever so slightly not completely sealed against the body of the door but it's really not a big deal. Glad to hear it worked out for you

 

yeah luckily when I had mine breaking it was only one side at a time....would have sucked hard core if both door handles broke at the same time and been locked out of the truck entirely. That's why I was always quick to replace them even though I hated doing it lol.

 

I got some of this going on Not this bad though. Under coating hides all you problems!

 

Got a Softopper

 

I picked one up a couple years ago off of Craigslist for $120 in decent condition, it was a early model (1st design) one. I really liked it but the freaking velcro on the back never stayed on and I ended up putting heavy duty velcro on my tailgate and it still didn't work...then after I sold the soft topper that velcro wouldn't come off easily lol. Took some paint with it...was a nightmare. To this day I'm still getting that adhesive residue off.

I really do like how soft toppers look on 1st gens but mine just didn't work out, I know they've had a few redesigns over the years so I'm sure the one you got is way better than the one I did.