Custom overhead console switch plates

Just click his name and view his profile and look at his postings/threads it’s not hard.

He’s got like 4+ products + additionally 3+ feeler threads or product idea threads and many of which were created long before this one. It’s all his side thing at the moment so he pick and chooses which one to proceed with 1 at a time.

 

Don't take it personal I am just stating a fact regarding this thread.
I don't browse 3rd Gen Build threads that much so I didn't know he had one.

I know he has additional products. I know he is/was doing this part time. Though some say he is starting to do it full time.

I have his map and overhead leds.

 

I didn’t take it personally I’m just pointing out it’s easy to click and find his recent posts/threads to see which products he’s devoting time too and which ones are currently on side burner.

 

Obviously this one is on the side burner since he isn't posting in it.

The others I am not following because I have what I need or they are products im not interested in.

Looking back the original poster who I asked for a link from was just trying to point out that the OP is still active on the forum (which I didn't doubt). But doesn't really show he is active on THIS specific product.

 

Ok.

 

There is this too:

https://mesocustoms.com

 

Now that is how you show off parts..

 

What paint?

 

Hey guys! I am not dead..don't worry
Over the past few weeks I've had my hands full getting other products to market and getting my new website up to speed. All my custom switch panels(these and 3rd Gens) have been on hold until I figure out a better way to categorize all the different configurations to make it easier to navigate on the site. Also, I need to finalize prices with & w/out painting. I have not forgot about these...

 

Just so long as they're not on hold while you look for investors

I'd still be down for a 5 Carling switch model

 

Think it's all Our fault for wanting them too much.

 

@mesojdm Could I get one for mine so I have a place for one of my Overlandbound plaques? I can get you measurements. Maybe even an extra place for a TW coin or two

 

..watching and hoping I don't miss out on these. Any idea of when your going to offer them?

 

Id love one for a switch pros!

 

Would really like to have the overhead console switch but thinking I may have to go this route so I can get the wiring done. www.tacomaworld.com/threads/center-console-switch-panels.434200/
Anyone have this setup?

 

Yes I do, quite enjoy it

 

I've got an extra one of these switch panels to sell - if you're interested PM me.

 

I borrowed the idea from Iggy's panel to make mine out of abs.
The backlighting on the guages isn't quite up to snuff(another diy fail) so I added a 3mm led under the upper diy panel(also abs to match).

It's angled back towards the guages and wired together with a resistor but I haven't tested it to see how well it's aimed or if the R-value is right. There's a big difference between visible and illuminating.

 

The overhead location is more convenient to reach I think, or would be if the switches were angled back toward the driver instead of at the floor. I did this one first because of the air lines to the guages and pressure regulator. The upper one was a follow on to change out the two 12V sockets for 3 additional switch locations while converting one to a usb + 12V guage.

 

Overhead switch consoles are available for 3rd gens but not 2nd gens