AZ BS Thread 4.2⁰

Thanks Cliff

 

@Aw9d you still looking for a trailer?

 

You're going to want to clearance the rub. Lift only hides the issue. There are a few people on here that can cmc for starters

 

Yep for sure, I just need it level and i think a CMC with a good alignment will fix the problem with minor fender trimming.

 

What size tire and what rear spring?

 

285/70/17 metal tech 3" spring

 

CMC should cover most of the rubbing, didn’t have to do any plastics when the runner was on 285/70s, 285/75s was a different story. The rake will always be subtle with the 3” springs. Look into an adjuatable tracbar eventually, the rear ending is likely shifted over a little bit to the passenger side.

 

Needs sliders


Pm me if interested

Could probably bust out that cmc for ya as well

 

That will help on the road but off will be a different story.

 

Ah ok. Well that sucks

 

Nice man, glad it’s working out for you.

 

Yes I am

 

Sending txt.

 

same, used one when the oil drain bolt stripped out on the BMW

 

@phx13

 

https://vancouver.craigslist.ca/nvn/snw/d/for-sale-snow-cat-limo/6690774296.html

 

Dibs

 

X2 on @Milota95

 

I’m not to educated on the topic, but is the needle bearing something that should be replaced over time? Kind of wondering about it since you can hear a grind sometimes. Don’t want a catastrophic failure.