Colorado B.S. Thread

I know praying he stays under 100 but It is what it is.

 

I have done a roller paint job on a Tacoma before. I had a bunch of orange peel, which i didn't mind. If you take your time it can turn out pretty good.

I also used tractor paint.

 

I had seen Heaton Bay on a few of my Google searches.

Since there are "Pay camp sites" I must ask, are there Non-pay that might be open? Or will I kinda be shit outa luck here

 

Sorry to hear that, yeah he's my cousins.

Nice, I'm not going to be picky... Probably going with cement colored paint.

 

Sounds like a concrete plan

 

Got your parts this morning. I can probably get them to my brothers shop off Broadway and Belleview by the end of this week

 

Just have to be the hunters in. I would recommend a ton around Taylor Reservoir but with Cottonwood Pass closed it adds about an hour onto trip to get there.

 

I'll take what I can get at this point if you recommend any specific spots around there. 4 hour drive or not, I bet it's worth it to go. Pictures look nice out there

 

Electrical what the actual fuck... Any ideas?

Edit: looks like wiring issue on one trailer popping fuse on trucks

All of the sudden, two trailers have all lights other than running lights. Brake, turn signals and electric brakes work.

Four different vehicles connect with same issue, prongs are clean. Chevy, GMC, Dodge, Toyota. 7 prong connector.

If i jump directly to the prong for running lights with 12v, lights work.

Waiting on a multi meter but jumping from the same prong on a couple of the vehicles, no lights. Lights worked fine before and the wiring is the same (position of running light prong)

Any clues?

 

If you apply 12v to the trailers via a battery or alternative source can you get them lightening ?

 

.

check the ground from the running lights (sockets) themselves to the trailer frame.

 

Looks like the enclosed trailer has a wiring issue somewhere and it popped the fuse on whatever hooked up to it...and dump trailer was used after that, i now have continuity after replacing the tundy fuse.

 

yeah, maybe check the fuse too...

 

@303tacoma I go between Aurora (225 & Iliff) and Golden every day for work, if this helps you any.

 

Yah guessing it's the trailer wiring that rubbed on something and shorted or bad ground.

But, for now I'm trying the old Windex and black trash bag trick on the old beetle tint. Then might give her the rough side of a sander to get it one step closer to new paint...guess I'll be removing accessories as well.

It's pretty hot up here, can't imagine how bad it is down yonder.

 

Fucking sucks

 

Nice thank you
That would be great!!
I drive by Bellview and Broadway M-F 4-5 sometime in there

 

Thank you
I think I’m good I’ll let you know

 

I am hoping it'll at least make this tint pull off in one large piece.

 

I almost got away without putting on pants today..... almost.....