FS: Custom bed dividers, SoCal

Thanks for your support Mike!

 

So I just found out Rustoleum started making the aerosol bedliner in a tan color. Anyone interested in a special edition Desert Sand divider?

 

Any idea if they fit the 3rd gen?

 

I don’t have access to a third gen to test fit. From my understanding the 3rd gen bed is the same width but shallower by a bit. I haven’t researched exactly how much “a bit” is. If someone was interested and local enough to let me get a measurement it would only take a slight adjustment if needed.

 

I live in the Downey area, not too far.. I wouldn’t mind helping out my fellow 3rd gens.

 

I may be, for my third gen.

. What measurement do you need? I’ll go out right now, in the rain, and measure for you.


Have you ever shipped? Any idea on shipping to 18037?

 

Shipped my first one today. I may have over-packaged it but I got a few quotes for shipping that put me between $40-60 (not including the packing materials). I want to wait and see how this plays out before I decide to offer shipping as an option. I'm more nervous about damage in transit than the hassle of shipping on my end. I'll let you know, bud!

 

Thanks.

 

Two more!

https://youtu.be/4EI8JN-fSLo

 

Damn it, I'm interested but shipping even to Vegas is a pain

 

Just got mine already putting in work

 

Thanks for your support Trae!

 

Love mine! Thanks @GHOST SHIP

 

Pm’ed

 

Been looking into getting one. Ever find out measurements for 3rd Gen and with factory Tonneau cover? Live in inland empire.

 

I haven’t had the opportunity to see one in person yet. If you ever find yourself closer out west let me know.

 

Hey man, I'm near Northridge if you're still looking for someone to take measurements on a 3rd Gen, I have a Bakflip MX4 on my bed and I know the factory divider is a little bit high unless you turn the mounts upside down and modify it.

 

Thank you. I actually had the opportunity to build one recently for a third gen. So if you were interested in one, I already have the measurements and could get one going for you. Turns out the bed to rail height is different (about 3/4" shorter compared to a 2nd gen). I also know the EOM bed divider uses threaded knobs vertically to secure it to the brackets that attach to the rails and it interferes with most tonneau covers. Since I use threaded knobs horizontally into the rail, I don't see it being too much of an issue for most tonneau as long as the rail is exposed. Although with ever possible manufacturer out there it's hard to adjust for every possibility.

 

Shoot wish I would’ve saw this earlier today. So with Factory Cover sounds like it’ll be fine. I’m actually heading out to Santa Clarita in a an hour for work. Would’ve been perfect if I left a few hours earlier.

 

I move around for work as well and have some flexibility throughout my day. If you were interested, let me know!