Door sill protectors?

i just got around to installing mine on my 18 DCLB. I did the back first so if I made a mistake it was in the back where I seldom use. When I went to put the fronts on I noticed they were very long. So long they curved back up on the sill. I trimmed the edge so it would follow the curve. I actually got more coverage. I’m just wondering if I got the wrong ones. And yes I got the air bulbs out!

 

Just guessing from the lengths. I think you got AC on a DBLC

 

Those might be the ones for the ACLBs?

 

That’s what I’m thinking! Which with more coverage up front I’m not complaining. Back seats don’t get used a whole lot.

 

I have them on my truck coverage is about the same on front and back doors. Yours are way longer in the front and looks to be about 1/2 the length in the back.

 

Well now their on till they wear off! When I replace them I’ll double check the length. Until then I have a one of a kind set on a DCLB lol

 

I really need to install mine this weekend. Noticed a deep gash on the edge of the passenger side

 

Any tips for installing these? I have a set for my TRD Sport that I need to put on.

 

Like others have suggested i think you got AC however, I do like that the front offers more protection on yours
Here’s how mine look

 

Yes. I just trimmed it for the upward curve. Not complaining. I like the extra protection!

 

Curious where did you get the colored lettering from?

 

Follow the instructions, clean area well with alcohol, avoid doing it in the FL sun (cause it is freaking hot as hell), and have a beer afterwards.

 

I got mine from @rrentrop and they look great.

 

Got them from @rrentrop too.

 

I’m screwed then lmao, if it’s not sunny it’s rainy

 

I just finished putting mine on. That’s the AC but I like the extra coverage on the front. I couldn’t find instructions anywhere so I just did it like tint/vinyl decals. Clean with alcohol, wet with solution (few drops of dawn in warm water), make sure to wet sill and back of protector. Lay into place, they will slide right under the seal no need to remove trim and seal. Squeegee water out and clean up. I did find it extra helpful to pre- bend the protectors before hand. Made for much easier install.

 

Or better yet, gash it up and when you can't stand it anymore, cover it with the protectors

 

Makes me want to buy things I don't need for my truck just so I can have a beer after.