1st Gen Lunchtable Thread - General Discussion

You’re back. I thought you left us.
Trucks off at paint right?

 

Oh lol

Uh same thing as breaks. There is a bleeder right by the slave

 

Not yet.

 

Yup I'm not sure when I'll get it back. I did stop in on Weds and they were blocking it. They were hoping to paint it today or on monday. I'd like to get it back next friday. I need to get this truck put back together the amount of loose parts is making me mental

 

The slave is even easier to bleed then brakes. Just let it gravity bleed for a bit then a few slow pumps. Although I've also heard that it's better to not pump the clutch but just slowly push it down and hold it. I've always done the pump method though

 

Thats cool.

Ever decided what coil overs you are gunna get for the front?

 

I’m going to be changing both, do I bleed two times one at master first then on the slave

 

Yeah you bleeed the master before you install it. Then after its all together bleed the slave

 

Got it. I guess I’ll ask again when I put it in I’m concerned about adjusting the push rod and what not when In the vehicle

 

Ugh bench bleeding is my least favorite activity.

 

It's likely going to be Kings front and back with rear Deaver springs. I'm running out of good weather so it might have to sit squatting until spring. Me and Tyler's truck might look the same with the stink bug look

 

Thas cool
J59s? Or what deaver?

 

I didn't bleed my clutch master when I put it in, didn't know I was supposed to

 

Should I forgo ? I need to find a vice lol

 

Harbor freight. Its cheap.

 

Last time I put my clutch master in I didn't either, it's such a small piston assembly if you pump it a lot during normal bleeding it will be fine. But for big ones like the brake master it would probably never get all the bubbles out and be soft or irregular.

 

Haha slap some sense into me then, why and how do you bench bleed it?

 

Mine is kinda irregular.. maybe that's why lol