TTC ☆ OFFICIAL

What is achieved with the seat spacers?

 

If they made a spacer to bring the steering wheel back another two inches, I’d be down

 

https://media1.giphy.com/media/26BRIL53texMuRZra/giphy.gif

 

Oh ya, it nice today in the mid 30's

 

Raises the seat. Front, Back, or both. Like the power seat in the 4Runner.

 

Comfort is all. I was looking at doing something or changing seats when I found the seat threads. I am going to try it. If it don't work I am not out much.

 

when you cut the flare, are you cutting the top (part that hugs the fender) or the bottom (the part above the tire) of the flare off? Im okay with losing the inner liner if needed. I was going to order some fender liners available that are rubber and malleable. I would keep the existing liner if possible and save the sheckels for something else too.

 

Curious as to what changes. Height obviously but if it changes geometry to the wheel and pedals, it would be worth it. Right now the wheel is too far away or my knees are in the dash

 

Spacer under the rear rail mount gets your butt out of the "Toyota Bucket Seat Hole" and makes a big difference. In my case I wanted to raise the entire seat to match our 4Runner. There is now a 1/8 inch cant difference front to back and its just right.

 

Do you have the link to the threads

 

Poor Man’s lift kit.

 

Nice !! It’s pretty humid but temps are way cooler than they have been. Loving it

 

Wazzz up taco addics!!!

 

So the top part stays the same, just peel off and replace the 3m tape. So in this picture, my goal flare size was dead center above the tire; basically having the trim come right up to the flare before it bends towards the fender.. I took a marker from there and drew my curve to the front to match with my bumper. To the back I just kept the same size as the center (used a tape measure and held a marker and ran it down along the edge ) It's a lot easier to explain with me pointing like a monkey, we'll lock it down sunday

 

Pretty sure @tacopromatt did some kind of seat bracket rise on his 3rd gen

 

I prefer the bucket seat feel since my ass is larger than most. The problem I have is, I want to lower the front an inch and then lower the rear like 2.5 inches!!!!!!!

 

Anyone selling SCS Ray10's that plans to be at the meet?

 

You have a better chance of buying a kilo of H for 50 bucks.

 

Edit - Not that I'm condoning that practice......just sayin'. Pigs flyin' outta my butt will happen first.