NJ B.S. Thread

You have an OEM Back up Camera. MY 2005 never had a backup camera. I did install a front and rear cheapo Amazon camera last year.

My truck is driving and shifting fine as well.

 

Fck That. I'm doing it the easy route... waiting for Jimmy...

 

Yeah. I was only worried about MY code

 

I'm gonna order the switch from gunny just in case.


Also gonna swing by your house this week to pick up some stuff.

 

Cool. You should also let me borrow those baby tires again so I can use them to get an alignment

 

I can do that.

The Michelin 265's?

Or the Prius 215's would look awesome on your truck.

 

I don’t know. You think I can fit the 215s without rubbing anywhere?

 

Only if you remove the sway bar

 

@HolyHandGrenade

Before I order shit, I'll take a look at this connector tonight:

P0705 code: There are SIX bulletins on this code for US made trucks. All of them suggest checking this connector at the driver's kick panel for corrosion inside the connector.

 

And you'll need three inch wheel spacers.

 

I don’t know... Let me run it past my safety advisor first.

@Wheelspinner what do you think?

 

this little guy finally arrived...



@HolyHandGrenade & @stairgod I know you guys both run these as well from CVJ... The breather tube stays in until the install is fully completed correct?
They shipped me 1x spare small axle boot clamp as well, do they always do this? Should I be pulling the breather and using this new clamp??

 

Breather stays in until the axle is installed. It allows the boot to pop back out when it gets squished.

They always send that clamp. I have a few of them in the top of my toolbox. Just set it aside.

 

so I pull the tube after the truck is resting on its own weight on the ground?

 

Pull the breather tube only after the truck is back on the tires so that it is at ride height when you remove it.

 

thanks for the quick replies

 

You KNOW Floyd had one of these.

@Subway4X4

 

That's vintage stuff right there man!

 

I spy with my little eye... anyone here?