1st Gen Lunchtable Thread - General Discussion

They end up in general vehicle auctions online and in person. The main U-Haul assembly and distribution plant for the US is a block away from my work. I'll ask them when the next auction for your area will be

 

Thanks, that would be great.

 

It can’t be 6x6. Wouldn’t there have to be two actual real axles with three wheels per side?

But it’s not technically 4x4 either.

I’m confusing myself.

 

I only count them as part of the drive if they can move separately from each other.

 

You’re right. It does say that.

 

That’s a good point. So it must be 4x4

 

Soo. Who has any advice on painting leaf springs

 

I just learned what 2HI, 4HI, and 4LO meant six months ago. This just boggles my mind to no end.

 

Don't it won't last, thin ductile powder coat is the only thing that will last worth a damn

 

You forgot 2LO

 

Roller and house paint.... or flex seal

 

You'd love all the knobs in the cruiser for drive modes then. No less than 4 different switches/knobs/and levers to control how it drives

 

My factory leafs looked good after 170k miles. My deaver’s with 100k looked like they sat in salt water. My deavers with 20k miles look like they’ve been in salt water too...

 

Ok so, our truck’s are 4x4 but in 2 wheel drive, diff unlocked there’s only one driving wheel right?

On a dually it’d be 2 wheels correct?

If the dually has a locker it’d be 4 if it was locked in 2 wheel drive.

So using the front axle would be 5 or 6 wheel drive.


Or am I completely wrong?

 

My alcans look like ass

 

I’m almost ready to order new leafs just because I don’t want rusty ass leafs on my new frame lol

 

Take em apart and clean them up.

 

Im going to attempt too. I’m afraid the Teflon pads are gone though... and I don’t think those are easy to get

 

But there’s 2 different points of connect per side

 

Fuck it, race truck parts make race truck sounds.