1st Gen Lunchtable Thread - General Discussion

I don’t plan on staying in San Francisco. However, I do like the state.

 

shoulda asked me. woulda done it for $150


(i need more moneys. i do things for moneys)

 

Wanna do mine lol

 

bring it
you gotta pay for parts ontop of the 150. obviously. lol

 

Are you using a chisel bit or what? May make a harbor freight run Tmrw. Have an air hammer, just no bits. Cut with saw in 2 places?

 

If I'd known I would have asked you. I had alot done to it at the time. But oh well, I'll make sure to give you a ring.

 

usually get away with sawing through on spot. then a cutter bit

 

The people at my Costco dont ever go to the open pump if it's in front of someone else. So even if the line is 5 cars deep and I see that, I fucking pull in past all of them. I don't have to wait for all of them just cause they're too stupid or incapable of backing in. One dude even tried to get pissy with me about it, I told him if he wanted the spot he should have pulled into it, bitching at me while I'm filling up isn't gonna make it better.

 

Guess Ill buy these

 

yea one of them should work

 

If you use a air hammer the probably 1 spot. I banged it out by hand so i made 2 cuts

 

Really hoping these come out easier than I expect them to. Its 2 per leaf right? Or is the sleeve just in the front one?

 

Took me like 10 min per eyelet on my leafs

 

2 per leaf if i remember right. been a bit since ive done some

 

Ok. So just heat and beat out the rubber part and inner sleeve, then hacksaw/airhammer the sleeves. Doesn't sound too bad.

 

it isnt. just be ready for the smell.. and try not to breathe in the smoke

 

Worse comes to worse, theres a spring shop right next to my college, and I have a spare truck to use. But hopefully wont have to go there.

 

You'll do fine

 

Luckily 5lugs use a more simple way. And i can pop them out with a metal rod

 

As the internet tells me I will.