1st Gen Lunchtable Thread - General Discussion

I’m pretty sure 3rd Gen 4Runnera has working wood scoops.

 

All I know is I had to sell my trailer because I couldn’t leave it in the driveway. And we got fined because I parked it under the deck.

 

Mine sits in the backyard except Monday nights, Tuesdays, and Wednesday mornings since I mow Monday and Wednesday and I don't feel like driving through the neighbors yard to put it away between mowing days. I will say though that HOAs do keep people from storing obnoxious things like RVs and Semis in their yards. I mow in a neighborhood with no HOA and some peoples homes look like shit and they have RVs, Boats, Tractors, Semis, etc stored in their backyards and it just looks bad. I just want to move and have some land so to see my closest neighbor I'd have to hop into my truck to visit lol

 

I trade the FOREX markets for a living. https://www.investopedia.com/terms/f/forex.asp

 

well my day got shitty. Mommas car needs a rear main seal. guess im going to be busy trying to drop a subframe with engine and trans and no lift.....

 

Sounds lame, just buy a lift lol

 

radiant heat wont allow me to do it. cant anchor it

 

checked where all the tubes are. id be anchored in 2 spots no matter how i move the rack

 

Damn that sucks

 

That usually means you pissed someone off. Probably someone on the board has a competing business, or you didn't wave at them nicely enough one time.

 

A lot of you guys run wheel spacers yeah? What's the 'normal' safest size to run? I was always opposed to them thinking they were unsafe for a truck that wheels but it seems like more people than not have some kind of wheel spacers on, even on the trails.

Would like a bit of a wider stance especially since going with skinny 33s, but don't want to compromise my wheel bearings or reliability in general offroad.

 

We went thru this already. Map out the loops and put the lift over the tubes.

You got a Gregg Smith equipment 2 hrs away.

 

How close are your tubes? Mine are 12". I had no trouble spanning mine.

 

If I could get maybe another inch width that'd be as much as I'd go. Was thinking maybe 3/4" spacers and see how it works/looks. I don't want to end up flinging a ton more rocks and dirt at the side of my truck than I already do without front mudflaps.

 

i've mapped out the loops when we fired up the heat. it just seems like theyre too close for a lift. eh. maybe i'll just say fuck it and have a rack installer come out

 

they closer towards the wall then expand out to 12" in the middle bay. Rack would be going in the 3rd bay which is where its tight

 

@JKO1998 Think you can find me a Civic Type R?

There’s like three freakin’ Type R’s in Northern California.

 

Same, my perimeter loops are at 6" and the rest is at 12".

 

from my understanding thats how a proper radiant is suppose to be setup, id probably be fine with it in the middle bay, but length is the issue there. 3rd bay is the longest bay. by 6 ft to be exact

 

Huh there isn’t a type R option.


Also, no you don’t need another vehicle