Built For the Internet...By the Internet Mall Crawler (AR15xAR10's Build Thread)

Added to op:

Communications:
-Uniden Bearcat 980ssb
-4ft firestick
-Cellphone/bluetooth
-Smoke signals/flares
-Hand Signals

 

I need to get a lot of those hand signals. To quote Marilyn Manson, I don't have enough middle fingers.

 

Have a constant coolant leak at this hose. Any idea how to remedy? @Torspd

 

Might be drastic but what about some high heat rtv sealer? You'll have to cut the hose off though.

 

its just because of those damn tabs on the neck of the radiator, i may just pull the hose back and pray its on there enough not to pop off when hot and under load

 

Maybe a larger hose clamp. Something heavy duty, like this

$10 Pro Tie 33704 Range 1-7/8"-2-3/16" T-Bolt All Stainless Hose Clamp, SAE Size 32 1-Pack

https://www.amazon.com/dp/B006IOZ9FI/ref=cm_sw_r_cp_awdb_t1_YIrZBbS8EA2TB

 

I dont know, maybe i'll email HPS

 

Good choice!

 

Intermediate shaft ordered @EatSleepTacos

Also ordered my clock spring assembly so expensive

 

It’s like driving a whole new truck with a new intermediate shaft. It’s ridiculous.

 

Was flying into a turn this evening and the wheel would not turn. It was like breaking a piece of fire wood in half that you didn’t split far enough with the hatchet. Ridiculous is right. Can’t believe i haven’t wrecked yet it binds so badly

 

What the hell is that?!

 

This bad boy

https://www.tacomaworld.com/threads/the-lair.495066/page-1772#post-17351582

 

Oh yea, I remember that. As soon as I saw the tie downs it clicked. Thanks.

 

The universal joint on my steering shaft

 

So they just get gunked up and stop working?

 

Pretty much. All universal joints eventually wear out. The truck is 11 years old

 

Are they greaseable? (is that a word?)

I actually greased the two on the front drive shaft on mine last weekend. I couldn't find any zerks on the rear shaft.

 

Nope.

 

Sux!