1st Gen Lunchtable Thread - General Discussion

Huh.

 

Do you think before you say anything?

 

You’ll grow out of that, I think

 

@BartMaster1234 look at this antique

 

Didn’t have any tims in the vehicle...Canadian foul

 

Not done yet, still need to mount it to the a pillar and actually make it functional (mount to the air intake), but she's mostly there

 

Lid is very pitted. Looks like I’ll have to whip out the Bondo.

This is after a pass with a 60 grit flapper disk.

 

Are you really planning to bondo a job box?

 

Mall new access level unlocked?

 

Can't beat a nice, healthy looking box

 

Patina can't fake the funk

 

I don't think he should take any short cuts here. Cut it out and weld in new metal, that's really the only option.

 

C’mon, are you really surprised?

 

Why not just prime and spray bed liner shit on the top of it?

 

It’s not that bad. I’ll go over it with 36 grit tomorrow and go over it with some bondo and glazing putty. I have some filler primer if that doesn’t work.

 

That's a halved ass job. I expected more than that from you.

 

I hate bed liner for exterior finishes. I like a nice shiny/matte finish toolbox. The inside will get bedliner.

 

With the way I weld, it’ll look worse.

 

Sweet, just a tip. Paint the inside white. You can find stuff easier.

 

Well that's why they make grinders.