POS Door Lock Actuator

Has anyone verified if the correct motors are the 10mm or the 20mm?

 

Do you

 

Does anyone have an updated link for the actuator motor? The current one isn’t working and I’m not wanting to order the wrong one.

 

You need a 20mm shaft that is keyed "flat shaft"

https://www.ebay.com/itm/Mabuchi-Ni...r+flat+shaft&_from=R40&rt=nc&LH_TitleDesc=0|0


When i did this i accidently bought 20mm long round shaft... I took a dremmel and flattened the shaft to key it myself. Also you can put the motor in "backwards" in that its flipped 180 so the polarity spins the motor backwards, if you do this (like i did) and dont want to pull the door lock actuator all the way back apart, you can much easier flip flop the 2 pins on the harness side to re-reverse the polarity to the motor haha.

 

Would this be the correct one?

 

Bah! mine just went out on the drivers side door. Brining this thread back from the dead! Mine is an early 2012 DCLB. Do I need the short or Long can't seem to find the details about what years have what?

 

The picture just above your comment is the one you need. I purchased that one for my 2013 DCSB. But it’s a pain to put the actuator back together because the parts sprung out when I opened mine. I couldn’t get mine to work once I put the new motor in and ended up getting the whole actuator assembly from eBay for 100$ and it works perfectly now.

 

I ordered two of the motors long stem off ebay will give it a try. found a good youtube video. https://www.youtube.com/watch?v=FZCeeUWMTcY
hope this will solve the issue or will have to drop the cash on the whole assembly.