TRD/ Magnuson 4.0 Supercharger Tips, Tricks, and Mods

Yes! I need to tighten my JFR belt wrap too. Didnt want to max out the new belt assembly for a week or so.

 

Did you just swap out your tensioner?

 

No. Sent the steeda back. Might get screwed with a restock fee too. Yay. Installed quick change, 2.5 and a greenbelt when my fuel pump got installed a week ago.

 

I did see it but I'm glad you reminded me because I've been... forgetful all this week to put it lightly. Lol.

I need to see your original post and if you can find that and just put it in a quote for me so I can scan the info that would be awesome. The information on this thread is a fleeting thing if you are not quick.

 

This thread is your baby and you don't remember all 520 pages?

 

Here you go sir

 

Damn it Murph! You shouldnt have posted. You had 1320 posts until the last one.

 

It shouldnt if you get the hub removal plate. I got one from Nate for I think $20.

 

I did not even notice

 

I put it about 2-3 inches downstream from where the y pipe goes to the single pipe (IIRC). I can’t take a pic for a while as I don’t have the truck with me. But I will get one when we are reunited haha

I believe I ordered this one (size-wise)
https://www.summitracing.com/parts/sum-690125/

The 2.5” fits 2.25” - 2.5”. There is also a 3” that fits 2.5-3.0 I believe.

 

I have a good reason. A concussive one at that!

Thank you sir!

Keep the posts down guys. I need time to review all this stuff so I can to update page 1. The information recently discovered and being discussed as a whole lately for our blowers has been nuts!

 

Damn it! Where was that tidbit when I ordered my pulleys from him?!?

Looks like another order from Nate...

 

The hub is a billet item. Billet is incredibly tough and resilient to stresses like the ones involved when pulling. That being said, it is always best to use the proper tool needed to pull the hub to avoid damage to the shaft or to the hub itself.

Both pulleyboys and smoothflow offer the puller for fairly cheap, though you shouldn't need to pull the hub at any point if you plan on servicing the blower. Unless you need to do work to the snout shaft for whatever reason.

 

I've actually bought every single thing they sell.

 

still on the 2.5" pulley?

 

2.6

 

You’re a bad man. I was fun though. Thread up in flames. Ha.

 

I 3rd! Pulley on my bench.

 

Need to get everyone out here to Idaho and come play in the St. Anthony sand dunes. I would love to hear what you all think of them. Cause around here, they are heaven. People travel from all over to ride them with their bikes, wheelers, sxs's, and sand rails. But very few take their trucks out on them. But I do! Along with a few others. Love the dunes. But also feel really bad for bouncing off the rev limiter as much as I do in the sand. Complete opposite of rock crawling or hitting the mountain trails. But if anyone is in the area of southeast Idaho, let me know. Could do the dunes and Yellowstone. Fun for the whole family!

 

Never been to that part of Idaho even though I grew up minutes from the border. Ever here of elk wa?